Grizzly T32794 User manual

For questions or help with this product contact Tech Support at [phone] or [e-mail]
MODEL T32794
UNIVERSAL SHARPENING JIG FOR
T32720 WET GRINDER
INSTRUCTIONS
COPYRIGHT © JULY, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 07/21) #CS21968 PRINTED IN CHINA
Introduction
The Model T32794 Universal Sharpening Jig pro-
vides support for tool sharpening on the Model
T32720 10" Wet Grinder.
Description Qty
A. Jig ............................................................... 1
B. Knob Bolts M6-1 x 22 ................................. 2
Inventory
Figure 1. Example of Model T32794 in use.
V1.07.21
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Figure 2. Inventory.
A
B

-2- Model T32794 (Mfd. Since 07/21)
Using Jig
Attach the jig to the tool rest on your Model
T32720 10" Wet Grinder to sharpen chisels and
other tools.
To use jig:
1. DISCONNECT GRINDER FROM POWER!
2. Install tool rest (refer to Grinding Wheel
Rotation on Page 23 of Model T32720 own-
er's manual to determine best way to install
tool rest for your operation).
3. Slide jig onto tool rest and install (2) M6-1 x
22 knob bolts (see Figure 3).
Note: Leave knob bolts loose enough to
move jig until directed to tighten in Step 5.
4. Adjust tool rest closer to or further from grind-
ing wheel and tilt jig until desired grinding
angle is achieved.
5. Tighten knob bolts to secure jig position on
tool rest.
6. Connect grinder to power, and turn machine
ON.
7. Rest workpiece against jig (see Figure 3),
then use firm grip to guide it against surface
of grinding wheel to perform operation. Move
workpiece back and forth across surface of
wheel while grinding to prevent excessive or
uneven wheel wear.
Figure 3. Example of grinding chisel with jig.
Eye and face injuries and respiratory prob-
lems can occur while operating this tool.
Wear personal protective equipment to
reduce your risk from these hazards.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Jig
x 2
Tool Rest