Preparation
Caution
█ First time use: Run the appliance at least 4
times without adding coffee.
█ Please follow the steps 1 - 2 and 7 - 12 in the
“Brewing Coffee” section.
1 Remove all packaging and stickers and
dispose of them according to applicable legal
regulations.
2 Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. Please see full details in the
“Cleaning and Care” section.
3 Make sure that the appliance is placed in an
upright position and on a stable, flat, clean,
dry and non-slip surface.
Brewing Coffee
1 Pull off and fill the water tank F with the
required amount of water, but do not fill past
the “12” mark. The brewed amount of coffee
will be 10% less than the filled water, because
it is absorbed by the coffee grounds and the
fillter. The scale on the glass jug is marked in
coffee cups, e.g. 4 = 4 cups. For the good
coffee taste it is suggested to operate the
appliance with at least 4 cups coffee serving.
Notes
█ Use only clean, cold and fresh drinking water.
█ There is a drip hole on the back of the water
reservoir to prevent exceeding the capacity of
the coffee maker. If you add too much water, it
will drip out from the back of the unit.
2 Close the water tank cover A and open the
filter basket cover B.
3 Pull out the filter basket C.
4 Take a suitable paper filter (1 x 4) and insert
the paper filter into the filter basket C and
close the filter basket cover B.
Note
█ Use only one paper filter at each time. Make
sure that the paper filter does not bend or fold.
5 Fill the filter with the desired amount of ground
coffee. To do this, you may use the supplied
measuring spoon.
6 Insert the filter basket C back into the housing.
7 Place the glass jug H on the warming plate I.
Caution
█ If the filter basket C is not closed or the glass
jug H is not placed accurately, the drip-stop
function will not work properly. It could cause
hot water or work hot coffee to overflow.
8 Connect the plug to the wall socket.
9 Turn the appliance on by pushing the On/Off
button P.
– The On/Off button P illuminates and the
brewing process begins.
Notes
█ The brewing process can be stopped at any
time by pushing the On/Off button P again.
█ Ventilation slots D allow the steam output. Do
not block these during use.
█ The coffee machine has a stay-warm function
and can keep the brewed coffee warm for up
to 30 minutes when the machine is switched
on. In accordance with eco design guidelines,
the machine will automatically switch itself off
after this time.
█ The appliance is equipped with a drip-stop G
located underneath the filter basket C and
enables you to briefly remove the glass jug H
to pour coffee before the water has finished
running through the machine.
OPERATION ______________________________