Gryc 009.000.254-1 User manual

Firma Gryc Tomasz Gryc
ul. Chełmżyńska 180E, p. 220
04-464 Warszawa
Phone [phone]
www.gryc.com.pl
[email protected]l
Operating manual for 009.000.254-1 and 009.000.254-0 keypad locks
1. How to use
Locking and unlocking
Unlocking
I.Key in the manufacturer’s code: “1234” and press “OK”.
II. You will hear a long buzz.
III. When the LED lights up in green, the lock is unblocked.
IV. Turn the knob 180 degrees.
Locking
Turn the knob 180 degrees into the original position.
2. Settings
I.Changing the code
a) Key in the manufacturer’s code: “1234” and press “OK”. You will hear a long buzz and
the LED will turn green.
b) Hold the “OK” key down for about 2 sec. The LED will start flashing. Enter a new code
and press “OK”. When you hear a long buzz, the code has been changed.
II. Activating the public mode
a) Enter the code and press “OK”. You will hear a long buzz and the LED will turn green.
b) Hold the “OK” key down for about 2 seconds, when the LED starts flashing, press “OK”
again.

c) Enter the code “44”, then press “OK”. When you hear a long buzz, the public mode has
been activated.
III. Setting a one-time code
a) Press “OK”; the LED will start flashing.
b) Enter a one-time code (from 4 to 15 digits).
c) Press “OK”, when you hear a long buzz, the one-time code has been set.
d) * Remember: a one-time code can be used to open the lock only once, after relocking
the code is automatically deleted from the memory. If you want to open the lock again,
you must start the procedure of setting a one-time code again.
IV. Switching off the public mode
a) Key in the code and press “OK”. You will hear a long buzz.
b) Hold the “OK” key down for minimum 2 seconds. The LED will start flashing, press “OK”
again.
c) Enter the code “43” and press “OK” again. When you hear a long buzz, the public mode
has been switched off.
V. Switching on/off the code masking function
a) Key in the code and press “OK”. You will hear a buzz.
b) Hold the “OK” key for minimum 2 seconds. When the LED starts flashing, press
“OK” again.
c) Key in the code “42”, press “OK”; when you hear a long buzz, the function of
masking the code has been activated.
Key in the code “41”, press “OK”; when you hear a long buzz, the function of
masking the code has been switched off.
3. Functions
I.A forgotten code may be retrieved with a USB KEY. The code will be changed to the
manufacturer’s code: “1234”.
II. The function of code masking: you may mask the original code by entering a false code
before or after it (maximum 16 digits).
III. The alarm will be activated after an erroneous code has been keyed in four times. The
lock will be blocked for 60 seconds.
IV. Automatic low battery voltage message.
V. The lock comes with 3VCr2032 batteries. The last code entered will not be lost after the
battery has been replaced.
4. Problem solving
Problem
Cause
Solution
After keying in the code a
double buzz can be heard. The
lock opens with delay
Voltage too low
Replace batteries
After keying in the code a
repeated buzz can be heard.
The lock will not open
The knob is in a wrong position
Turn the knob to the right
position

No sound signal while touching
the keys, but the lock can be
opened
The buzzer does not work
Replace the buzzer
Video instruction manual –see our YouTube channel