GSW AAC-FM-1509SA1 User manual

AIR CURTAIN
INSTALLATION MANUAL
Thanks for purchasing this Air Curtain,
please read these instructions carefully before use.

1、 PRODUCT INTRODUCTION
As one of the new top-class products for modern decoration, air curtain is also matched with the
air-conditioner. And it is installed at the entrances of supermarket, theater, meeting room, hotel, office
room, working shop and storeroom to prevent the dust, mosquito and nocuous air, and so on.
2、IDENTIFICATION & INSTALLATION DIMENSIONS
MODEL A B C D E F H I J
AAC-FM-1509SA1 900 - - - - - -
AAC-FM-1510SA1 1000
- - - - - -
AAC-FM-1512SA1 1200
440
- - - - - -
AAC-FM-1515SA1 1500 840 - - - - - -
52 145 260 220 130
3、INSTALLATION CAUTION
Must follow the following asking when installing air curtain:
3.1Please install the unit in a sturdy place to avoid
the shaking and ensure its security. Because it
maybe causes the wall becoming flexible or shaking
and noise.
3.2 Please install the unit inside the room.

3.3 Don’t install the unit too low, no less than 2.3
meter from the ground.
3.4 When the entrance is wider than the unit, it is
recommended to install two or more units in
parallel. In this case, provide 20-40mm gaps
between the units.
3.5 Don’t allow gaps between the unit and the
wall. When hanging it from the ceiling, using the
enclosed ceiling braskets.
3.6 Don’t install the unit in a place where it is
splashed by water, exposed to excessive steam,
explosive gas or corrosive gas.
4、INSTALLATION
A、Installing on the concrete wall:
4.1.1 Removed the mounting plate.
Unclamping the fixed screws on the back of main
body to removed the mounting plate.
4.1.2 Fix the bolts in the proper position
(Decide the position with the mounting plate and
pour cement into the bolt holes.)

4.1.3 When the cement has freeze, fit the mounting
plate (use the washer and nut according to the
following).
4.1.4 Install the main body.
Set the main body onto the upper end of the
mounting plate and clamp it as shown.
B、Installing on the wooden wall:
C、Hanging from the ceiling:
4.3.1 Remove the mounting plate from main body
(Same as step 4.1.1)
4.3.2 Fixing ceiling brackets as below Fig.
4.2.1 Fix the mounting plate in the proper
positions with tapping screw.
4.2.2 Same as the step 4 of A

4.3.3 Set the mounting plate on the ceiling
brackets and ensure safe & fixing (use the bolts
attached to the ceiling brackets as Fig. Using the
ceiling brackets to hang from the ceiling, the
position of mounting plate can be adjusted in the
limit of 100 mm.
4.3.4 Do the same as step A to install the main
body.
D、For above ceiling:
4.4.1Fix the air curtain as in the procedure for
installing on the concrete wall.
4.4.2 The pipe as right Fig. Instructs.
5、TECHNICAL PARAMETER
Max input
power
(W)
Max air
speed
(m/s)
Air volume
(m3/h)
Noise
(dB)
MODEL Volt.
(V~)
Freq
(Hz)
H L H L H L H L
Net
weight
(Kg)
AAC-FM-1509SA1 380 300 2000 1600 67 65 13.5
AAC-FM-1510SA1 400 320 2300 1800 68 66 15.5
AAC-FM-1512SA1 530 450 2800 2200 69 67 17
AAC-FM-1515SA1
120 60
690 610
13 10
3600 2800 71 69 21

6、WIRING DIAGRAM
THERMAL CUT-OUT
DOUBLE SPEED SWITCH WIRING DIAGRAM
GREEN
(YELLOW)
BLACK
WHITE
BLUE(BROWN/RED)
YELLOW
ORANGE
C
K
2OFF
3HI
1LO
L
N
7、OPERATION
7.1 Turn on the power switch
7.2 Select the best speed：High[H]、Low[L]
7.3 According to the installation place to adjust the wind direction parts to obtain the best effect.
8、CAUTIONS
a)、Use the unit at the right voltage and frequency indicated on the nameplate.
b)、Disconnect power source before unit operation.
c)、Routing maintenance must be done every year.
d)、Never use petrol, benzene, thinner or any other such chemical for clearing the unit.
e)、Do not allow water or anything enter the motor.
f)、When power supply comes from socket, the plug must accord with IEC335-1.When the power cord is
connected with charging line directly, all polarity switches that the contact gap is 3mm at least must
be installed in the charging line.
g)、In order to avoid the injure ,must changed the line of air curtain by professional worker or factory when
the line happened trouble.