GT-Lite GT-BU-2500 User manual

1. Before installing the bulb, shut off power supply at the circuit breaker panel to avoid
electrical shock. It is recommended that surge/lightning protection be installed. This bulb is
not compatible with any ballasted fixture.
2. Remove old bulb.
3. Screw in new LED Motion Detecting bulb. (Lamp should be mounted with motion sensor (D)
facing down* towards the area where motion will occur.)
*It is not recommended to mount bulb face up or close to the ground
where water may accumulate on the sensor.
4. Individually pivot each of the 4 adjustable panels (E) to best cover the desired space.
Motion detection is 27ft diameter surrounding bulb when mounted at 10ft height.
*At an ambient temperature of 71-75˚F the detection distance is at max. As the
temperature increases or decreases, the detection distance may be affected.
5. Adjust motion sensitivity (A), time (B), and light sensitivity (C) settings to desired outcome.
(These settings can be adjusted at any time.)
6. Restore power.
7. Turn on light switch. Motion detection will begin immediately.
8. Adjust all settings and angles as needed. (Remove bulb for access if necessary.)
9. Do not look directly into LED lights when adjusting settings.