Guru-Z GX3-440x User manual

V1.1

Preface
Thanks for purchasing Guru-Z products. This Fiber Frame provides a durable and well-designed structure for different
size of tail boom, including 5mm, 8mm and 12mm tail rotor, for both 300/400class helicopter. Please read the manual
carefully before assembling the model. You may always get the latest online version of the manual via http://www.guru-
z.com/catalog/download.php
Key Features
Tools needed
•1.5mm philip “+” head screwdriver
•1.5mm Hex driver
•Plier
•Loctitle
•Grease
Notes on screws type
•Please use the screws carefully. Types of Screws used are shown below.
•Provide a platform for pilot to use their own rotor head and modify to suit their needs
•Compatible with most of the 300class EP helicopter rotors in the market.
•Rigid Frame structure and strong Motor mount
•Durable and elastic landing skid
V1.1

Install the bearing in the slot as shown
in the diagram. Bearing size varies to
model.
The Swash holder is installed opposite
to the stock version of the King.
V1.1

Make sure the belt guide can be freely rotate
after securing the screws.
V1.1

Install the parts as shown in the
diagram. NOT all holes need screws at
this stage.
Install Servo at this stage will be easier
V1.1

If you plan to use a bigger motor, you should install the motor at the stage.
GE38H Brushless motor are able to be installed after finishing the frame.
V1.1

There are 2 kinds of inter-frame
support. The 2 longer rods
should be install at the rear part
of the frame.
V1.1

You may choose to use the stock King 2
Landing ski.
Congratulation, you have finished the
assembly of the Fiber Frame and ready
for further electronics installation.
V1.1