Gymnova 2186 Instructions for use

17/02/22
2187/20
CS 30056 - 45 RUE G. DE FLOTTE
13375 MARSEILLE CEDEX 12 (FRAnCE)
TEL : [phone] FAX : [phone]
www.GyMnOvA.COM
NM304-GB
Keep this
DocuMeNt
AsseMBly iNstructioNs for MAiNteNANce
Constantly aiming to improve our products, we reserve the right to make changes to the equipment and dimensions without further discussion.
set of 4 replAceMeNt BeveleD pADs for
coMpetitioN spriNGBoArDs (2186 & 2187)
Warning:
This equipment should be installed by a qualified individual.
Using this equipment for purposes other than those originally intended is prohibited.
Compliance:
For this type of FIG-approved product, the replacement of spare parts (such as non-slip pads) does not maintain compliance with dimensional
requirements. This equipment will no longer be able to equip international FIG competitions.
Recommendations:
- Keep these instructions for subsequent reference (inspection, maintenance, etc.).
- Periodically carry out predictive maintenance.
- Depending on how much it is used have the equipment serviced yearly or every few years.
Tools required:
I. General maintenance:
iMportANt :
Regular cleaning of the apparatus makes it easier to spot any problems (distortion, breakage or moisture absorption).
Before each use, make a through check on good condition and correct operation of wear parts and safety elements:
- Check the condition of beveled Pads (1’) and and non-slip strips (4).
- Check the condition of springs, straps and tray.
- Check the tightening of all fixings.
- If a problem is detected or suspected, do not use the equipment as long as it has not been checked by a technician.
- Any damaged or distorted component should be replaced as quickly as possible.
- Plastic mesh- Water pump pliers - Phillips
screwdriver
- Large flat
screwdriver
1
1’
x4
2
3
3
Keep this
DocuMeNt

II. Disassembly of damaged old pads:
Plastic mesh Phillips
screwdriver
1
1
1
1
1’
1’
1’
1’
1’
4
4
4
1’
x4
2
3x4
1’
NM304 - Page 2
1’
3x4
x4
2
III. Mounting of new pads:
- Plastic mesh
- Water pump pliers
- Large flat
screwdriver
reMove All reMAiNiNG stAples froM the
corNers of the frAMe.
positioN eAch pAD At AN
ANGle of the frAMe.
• ceNtrAl fAsteNers of 4 curveD screws (2) iN rouND holes.
• corNer fAsteNers of 4 coNicAl screws (3) iN loNG holes.
MoDerAte MANuAl tiGhteNiNG: AvoiD crossiNG the BottoM of the pADs.
push All
reMAiNiNG clips
oNto the siDes of
the frAMe.