1
2
4 5 6
7
8
3
2
917
3
3
7
8
917
NM53e - Page 2
Figure 1
II. Maintenance:
1-A regular cleaning of the apparatus allows better viewing of the problems, if any (distortion, breakage, or corrosion).
2-Before use, check wear parts each time for good condition and operation: cylinder (12), stop tube (11) and standing board (1),
as well as presence of endpieces (19), (20) and (21).
3-Check the correct tightening of all attachment elements.
4- Important:
-If a problem is detected or suspected, do not use the equipment as long as it has not been checked by a technician.
-Any damaged or distorted piece should be replaced as soon as possible.
III. Storage:
Always store the equipment away from humidity and heat.
I. Assembly (minimum of two people required):
Note: Prepare a clean area for assembling the apparatus.
1-Installing the board (1) onto the rocking frame (2):
-Select the board (1) attaching direction (lengthwise as shown by Fig. 1 or widthwise as shown by Fig. 2), depending
on the requirement.
-Secure it using screws (4) + (5) + (6).
Figure 2
2-Installing the platform onto the apparatus upright (upper upright on asymmetric
bars with stays, or onto the ring frame Ref.: 3700):
-Important:this equipment should never be installed on rounded uprights. You are
strongly advised against installing it onto the high bar for training (Ref.: 3210B -
3125B), as the platform restricts the useful adjustment range of the apparatus.
-Position and hold the platform at the desired height against the apparatus upright.
-Fix the assembly using the tightening plates (7) and screws (8), (17) and (9):
moderately tighten to prevent distorting the apparatus upright.
