H3C ANT-2507P-S4 User manual

i
Contents
H3C ANT-2507P-S4 directional antenna installation guide····························1
Technical specifications·····································································································································1
Safety precautions ·············································································································································3
Installation guidelines·········································································································································4
Mounting the antenna ········································································································································4

1
H3C ANT-2507P-S4 directional antenna
installation guide
Technical specifications
The ANT-2507P-S4 dual-band directional Wi-Fi antenna is designed for use in indoor environments.
It is connected to the device through RP-SMA male connectors.
Figure 1 Antenna view
Table 1 Technical specifications
Item
ANT-2507P-S4
Frequency range •2400 MHz to 2500 MHz
•5150 MHz to 5850 MHz
Polarization type Horizontal and vertical
Gain 7 dBi
Horizontal beamwidth (HBW) 60 degrees
Vertical beamwidth (VBW) 35 degrees
Impedance 50 Ω
Voltage standing wave ratio (VSWR) < 2.0
Maximum power 20 W
Connector RP-SMA-J
Dimensions (H × W × D) 35 × 229 × 229 mm (1.38 × 9.02 × 9.02 in)
Weight (including the antenna casing) 0.43 kg (0.95 lb)
Figure 2 through Figure 5 show the horizontal and vertical radiation patterns.

2
Figure 2 2.4 GHz horizontal pattern
Figure 3 2.4 GHz vertical pattern

3
Figure 4 5 GHz horizontal pattern
Figure 5 5 GHz vertical pattern
Safety precautions
WARNING
!
•
Installing antennas carries some level of risk. For your safety, read the following safety
precautions carefully before your operation.
•
Keep the antenna away from power sources, street lamps, power distribution boxes, or other
places that might cause electrical shock.
•Do not touch any power lines for your safety.

4
•
Keep safety in mind when you select your installation site. Keep away from electric power lines
and other lines.
•
Do not work alone when you install the antenna.
•
If the antenna, antenna cable, or any other installation accessory drops, get away from it to
avoid bodily injury.
•
To avoid any potential hazards, always have a professional handle power connection rather
than attempting it yourself.
•
If an accident, for example, electrical shock, occurs, immediately call for qualified emergency
help.
Installation guidelines
To ensure optimal performance of the antenna, follow these guidelines:
•
Keep the antenna away from metal obstacles, such as heating pipes and air conditioners.
•
The material and thickness of walls determine the number of walls that the RF signal can
penetrate. 5 GHz signal attenuation is large. Avoid signal penetration through solid walls.
Mounting the antenna
1. Put the antenna over the AP front.
2. Use M2.6 × 6 mm screws to secure the antenna.
3. Connect the RP-SMA male connectors on the antenna to the RP-SMA female connectors on
the AP.
Figure 6 Mounting the antenna