Habitat Bilbao BILB-DT-SS20-A User manual

Bilbao Acacia Table
1 2
1
Assembly Instructions - Please keep for future reference
Dimensions
Length - 159cm
Width - 90cm
Height - 76cm
Important - Please read these instructions before assembly
If you need help or have damaged or missing parts, email:
or call: 0344 499 4686customerser[email protected].uk
BILB-DT-SS20-A

Safety and Care Advice
Check you have all the
components and tools listed on
the front cover and pages 3 - 4.
Remove all fittings from the plastic
bags and separate them into their
groups.
Keep children and animals away
from the work area, small parts
could choke if swallowed.
Make sure you have enough space
to layout the parts before starting.
Assemble on a soft level surface
to avoid damaging the unit or your
floor.
We do not recommend
the use of power drill/
drivers for inserting
screws, as this could
Take care when moving furniture-
dragging it across the floor will
loosen and damage the joints.
Always lift and move.
From time to time check that there
are no loose fitting. Tighten as
necessary.
Take care to prevent sharp objects
e.g. toys. buckles and heels from
coming into contact with your
furniture,and avoid contact with
chemicals
e.g. cosmetics or hair products
which may permanently mark the
surface
Dust regularly with a clean dry cloth.
Wipe up any spills immediately with
a damp cloth and then dry the
surface with a clean dry duster.
Repeat this procedure for periodic
cleaning.
Remove stubborn stains with a
weak washing up liquid solution
and a damp cloth and dry after
with a clean cloth.
Important: Recommended
maximum loading.
If for any reason you should
have problems with your Habitat
product, please contact the store
from which you purchased it.
Please retain your receipt as proof of
purchase.
If you have any comments or
suggestions regarding this product,
assembly instructions or service
received, please contact the store
or Habitat Head Office via its web
site: www.habitat.co.uk
or write directly to: Habitat Retail
Ltd. 489-499 Avebury Boulevard,
Milton Keynes Mk9 2NW
1 2 damage the unit. Only use hand
screwdrivers.
Dispose of all packaging carefully
and responsibly
Genral care and maintenance
Cleaning and care
General information
Maximum weight limit
2
Important - Please read these instructions fully before starting assembly
Assemble the item as close to its final
position as possible.
Do not place furniture directly in
front of radiators, fires or any other
source of heat.
Parts of the assembly
will be easier with 2
people.
This range can be used outdoors all year
around but to extend its life we
recommend covering it or moving it to
a sheltered area during periods of
prolonged wet weather and during the
winter months. Before covering, always
ensure that the product is completely
dry first, and that the cover has
ventilation.Never leave outdoor
furniture standing in water.
The use of furniture polish or spray is
not necessary or recommended.
Never use abrasive of corrosive cleaning
agents.
Always use place mats and coasters to
protect against moisture and heat.
Max.
40kg

1201151101051009590858075706560555045403530252015105
Components - Fittings
Ruler - To help correctly identify the fixings
3
If you need help or have damaged or missing parts, email:
or call: 0344 499 4686customerser[email protected].uk
Please check you have all the panels listed below
Note: The quantities below are the correct amount to complete the assembly.
In some cases more fittings may be supplied than are required.
ABC
M6 x 25mm Bolt x 12 Allen key x 1
M6/12 x 1mm Flat washer x 12
Acacia furniture needs to be re-oiled at least once every 6 months to maintain its good looks. Always use a dry finish
oil such as boiled linseed. Using a pigmented oil will help protect against greying and UV damage. Remember to
closely colour match the oil to your furniture to maintain the original colour.
1. Remove dirt and dust before re-oiling. Furniture must be completely dry before oiling
2. Rub down furniture lightly with 150-grit sandpaper
3. Closely following the oil manufacturer’s instructions
4. Oil once, let the oil dry
5. Sandpaper lightly with 220-grit sandpaper before adding the 2nd coating of oil.
IMPORTANT! Re-oiling your acacia furniture

BC
Components - Panels
4
If you need help or have damaged or missing parts, email:
or call: 0344 499 4686customerser[email protected].uk
Note: There are ‘Batch code’ lables where shown on the indicated items, these should be retained.
1. Top
2. Leg x 2
BC
BC

Step 2
5
Step 1
Assembly Instructions
1 2
AB
C
1 2
x 12 x 12
x 1
A
B2
2
1
Take care when turning table upright.
C
Once all the bolts are in place gradually tighten them until
they are fully tightened