Safety and Care Advice
Important – Please read these instructions fully before starting assembly
If for any reason you should have
problems with your Habitat product,
please contact the store from which
you purchased it.
Please retain your receipt as proof of
purchase.
If you have any comments or
suggestions regarding this product,
assembly instructions or service
received, please contact the store or
Habitat Head Office via its website:
www.habitat.co.uk
or write directly to: Habitat Retail Ltd.
489-499 Avebury Boulevard,
Milton Keynes MK9 2NW
General information
2
Check you have all the
components and tools listed on the
front cover and pages 3 - 4.
Remove all fittings from the plastic
bags and separate them into their
groups.
Keep children and animals away
from the work area, small parts
could choke if swallowed.
Make sure you have enough space
to layout the parts before starting.
Do not stand or put weight on the
product, this could cause damage.
Assemble the item as close to its
final position (in the same room) as
possible.
Do not place furniture directly in
front of radiators, fires or any other
source of heat.
Parts of the assembly
will be easier with 2
people.
Assemble on a soft level surface
to avoid damaging the unit or your
floor.
We do not
recommend the
use of power drill/
drivers for inserting
screws, as this could
damage the unit. Only use hand
screwdrivers.
Dispose of all packaging carefully
and responsibly.
Take care when moving furniture -
dragging it across the oor will loosen
and damage the joints. Always lift
and move.
From time to time check that there are
no loose ttings. Tighten as necessary.
Take care to prevent sharp objects
e.g. toys, buckles and heels from
coming into contact with your
furniture, and avoid contact with
chemicals e.g. cosmetics or hair
products which may permanently
mark the surface.
General care and maintenance
1 2
Dust regularly with a clean dry cloth.
Wipe up any spills immediately with
a damp cloth and then dry the surface
with a clean dry duster.
Repeat this procedure for periodic
cleaning.
Remove stains with a weak washing
up liquid solution and a damp cloth
and dry after with a clean cloth.
Stubborn stains can be removed
from the oak table top by lightly
sanding with a ne grade sand
paper and then re-oiling.
Please see re-oiling instructions below.
The use of furniture polish or spray
is not necessary or recommended.
Never use abrasive or corrosive
cleaning agents.
Always use place mats and coasters
to protect the surface from moisture
and heat.
Cleaning and care of wood, wood veneer and metal
Important: Recommended
maximum load
Maximum weight limit
Avoid exposing your furniture to direct
and prolonged periods of sunlight and
heat sources as fading and cracking
may occur.
Max.
50kg
Max.
20kg
Max.
20kg
Re-oiling instructions for oak table top
This oak table top should be re-oiled with linseed furniture oil several times a year to help retain its good looks.
Before re-oiling, remove small stains or marks by lightly sanding the surface of the wood with a ne grade sand paper.
IMPORTANT! Read and follow oil supplier’s directions carefully!
Apply a generous coat of linseed furniture oil to the complete table top.
Allow the oil to fully absorb into the wood - follow the oil suppliers directions.
Wipe with a clean dry cloth before use.
