Tools required (Not Supplied)
Component parts
Pop-up Worktop Socket
Assembly guide
•Make sure all the components are included before
you start.
• The number for technical support is at the bottom
of the page.
• Don't rush!
• Read the instructions first.
• Assemble in the stages shown.
• Keep the fittings together to avoid loss.
• Have fun.
Did you know Häfele also supply tools to the trade and industry?
See www.hafele.co.uk for more information.
FITT-10076
Issue - 01
Sales and Technical Support -
1 x Worktop socket and 2000 mm power cord with 13 A plug fitted 1 x Threaded locking ring
1 x Template
1Cut out 92 +2/-1 mm diameter hole in work surface;
ensure minimum distance from edge is 25 mm.
Template enclosed.
The unit should be conveniently located to allow easy
access to the unit and positioned near a socket outlet
where the power cable can be plugged in. Ensure that
there will be sufficient space under the worksurface
for the unit when in the retraced position and that
it will not interfere with anything. Allow for enough
cable slack for the unit when retracted or extended.
Do not position near taps or where the unit will be
difficult to access or operate where the power cable
may be trapped or put under strain.
IMPORTANT:
If in doubt installation must be carried out by a qualified electrician
Minimum installation distance from edge of worktop is 25 mm*
Install on smooth flat surface only
Do not install over jointed or uneven surfaces (e.g. tiles, melamine joints etc.)
Users must not bend the handles beyond their natural vertical position and
both handles should be returned to their resting positions when pushing the unit down.
Before you start...Check the pack and make sure all the components are included – if not call the
Helpline on 01788 548800 and our team will get things sorted. When you are ready to start make sure you have the
right tools to hand, plenty of space and a clean dry area for building. Don't rush, read the instructions first and run
through the sequence before you begin. Assembly should be done in the stages shown in the following diagrams, keeping
fittings together to avoid loss.
Cleaning - Use damp cloth only, ensuring power cord is disconnected from mains supply.
2Remove the threaded locking ring from the unit.
Insert socket into hole from above. Align dot on
threaded collar with dot on threaded locking ring
and then screw on tightly against underside of
work surface.
Ø 92 +2/-1mm
**
Jigsaw
