HAI OMNI LT User manual

Installation
Simplified…
by
July 2007

Cell Phones
As a courtesy to all,
please set your cell phones
to silent.
There will be a break to
return phone calls

Installation

System Controller: Omni LT
EARTH
GROUND
TRANSFORMER
16.5VAC 40VA AUXILIARY 12VDC
SOUNDER CONSOLE(S) ZONE
INPUT INPUT
ZONE REMOTE
CONTROL
THERMOSTAT(S)
OUTPUT
OUTPUT
CONNECT CABLE
TO CONTROLLER,
PLUG MODULAR
END INTO
RJ31X JACK
INPUT
ZONE
INPUT
ZONE INPUT ZONE
INPUT
ZONE INPUT ZONE
INPUT
ZONE
OUT2
BURGLARY
ZONE
ZONE
(NC)
1K EOL
ZONE
UNIT AND DISCONNECT
Z8
BEFORE SERVICING.
TELEPHONE LINES
4-WIRE FIRE ZONE
EOL
COM
OUT2
SWITCH 12V
WARNING
DE-ENERGIZE THIS
FROM ELECTRIC SHOCK,
TO PREVENT RISK
(NO)
SMOKE
ZN
12V
4-WIRE ZN
1K
12V
SMK
NRMJ9
2-WIRE FIRE ZONE
Z8ZONE
ZN
SMOKE
2-WIRE
12V
NRM
SMK
J9
AUXILIARY 12V, CONSOLE, AND OUTPUTS ARE INCLUDED IN THE TOTAL DEVICE LOAD, WHICH CANNOT EXCEED 0.5 AMP.
SOUNDERS CANNOT EXCEED 1 AMP. IN UL INSTALLATIONS, SOUNDERS CANNOT EXCEED 350mA.
NOTES:
3.
2.
(OUTPUT)
EOL
1K
(OUTPUT)
SWITCH 12V
ALL CIRCUITS EXCEPT FOR THE BATTERY ARE POWER-LIMITED (CLASS II)
IN UL INSTALLATIONS, THE TOTAL DEVICE LOAD CANNOT EXCEED 200mA.
1.

System Controller: Omni IIe / Pro II
EARTH
GROUND
TRANSFORMER
24 VAC 40 VA
INTERIOR
SOUNDER
SWITCHED
12 VDC
AUXILIARY 12 VDC CONSOLE(S)
REMOTE
CONTROL
THERMOSTAT(S)
EXTERIOR
SOUNDER
1A Max.
(See NOTE 1)
1A Max.
(See NOTE 1)
(See NOTE 2)
OUTPUT 100 mA Max. (See NOTE 1) OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT
ALL CIRCUITS EXCEPT FOR THE BATTERY
ARE POWER-LIMITED (CLASS II)
CONNECT CABLE
TO CONTROLLER,
PLUG MODULAR
END INTO
RJ31X JACK
ZONE
INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT
ZONES 1-16 ARE CONFIGURABLE FOR BURGLARY, FIRE, TEMPERATURE, OR AUXILIARY.
2-WIRE SOMKE DETECTORS MAY ONLY BE CONNECTED TO ZONES 1-4.
INPUT
ZONE
INPUT
ZONE INPUT ZONEZONE
INPUT ZONE INPUT ZONEZONE INPUT INPUT
ONLY ZONES 9-16 MAY BE CONFIGURED AS ENERGY SAVER ZONES.
ONLY ZONE 16 MAY BE USED FOR REMOTE CONTROL THERMOSTATS.

Lumina and Lumina Pro
EARTH
GROUND
TRANSFORMER
24 VAC 40 VA
INTERIOR
SOUNDER
SWITCHED
12 VDC
AUXILIARY 12 VDC CONSOLE(S)
REMOTE
CONTROL
THERMOSTAT(S)
EXTERIOR
SOUNDER
1A Max.
(See NOTE 1)
1A Max.
(See NOTE 1)
(See NOTE 2)
OUTPUT 100 mA Max. (See NOTE 1) OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT
ALL CIRCUITS EXCEPT FOR THE BATTERY
ARE POWER-LIMITED (CLASS II)
CONNECT CABLE
TO CONTROLLER,
PLUG MODULAR
END INTO
RJ31X JACK
ZONE
INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT ZONE INPUT
ZONES 1-16 ARE CONFIGURABLE FOR BURGLARY, FIRE, TEMPERATURE, OR AUXILIARY.
2-WIRE SOMKE DETECTORS MAY ONLY BE CONNECTED TO ZONES 1-4.
INPUT
ZONE
INPUT
ZONE INPUT ZONEZONE
INPUT ZONE INPUT ZONEZONE INPUT INPUT
ONLY ZONES 9-16 MAY BE CONFIGURED AS ENERGY SAVER ZONES.
ONLY ZONE 16 MAY BE USED FOR REMOTE CONTROL THERMOSTATS.

Phone Line Seizure
RJ31X Jack
Phone Access
Local
Remote
Central Station
Computer Access
Bend tab up if
necessary to
ensure tight fit.
RED
GRAY
GREEN
GRAY
BROWN

Specifications
OMNI IIE,PRO II,LUMINA and LUMINA PRO
Controller Maximum Group Current Outputs:
Console: backlight off – 35 mA; backlight on – 100 mA
Outputs 1 – 8 100 mA
Devices: Aux 12 VDC, Switched 12 VDC, Console, and Outputs 1 – 8: 1 amp max
Horn: Int Horn and Ext Horn: 1 amp max
Operating Temperatures 32 – 122 degrees F ( 0 – 50 degrees C )
Transformer: 24 VAC, 1.67 amps, 40 VA
Battery: Rechargeable Sealed Lead Acid, 12 Volts, 7Ah

Specifications
OMNI LT
TYPICAL CURRENT CONSUMPTION AT NOMINAL VOLTAGE
Console : backlight off, 35 mA
Backlight on, 100 mA
CONTROLLER OUTPUTS UL RATINGS MAXIMUM
Devices : Aux 12 VDC, Console, and Outputs 1 and 2 : 500 mA Max
Bell : 1amp Max
Outputs : outputs 1 and 2 each have a max current draw of 100 mA
Battery : 12 Volts 7Ah Sealed Lead Acid
Operating Temperature 32 – 122 degrees F ( 0 – 50 degrees C )
Transformer : 16.5 VAC 40 VA

Console Connection