Haier GE UAWB46A User manual

131-5000502 Rev. 0 04-20 GEA
Installation Instructions
Wind Ba󰀪e
WARNING
!For personal safety, disconnect system power before installing this accessory.
During installation, if ground wires, screws, straps, clips, or other means of attaching grounding
components are removed, they must be returned to their original positions and fastened securely.
!IMPORTANT SAFETY NOTICE To avoid personal injury or property damage, this accessory
is to be installed only by a licensed and trained industry professional. The manufacturer will not
assume liability for unqualied installers or failure to follow these instructions.
Model: UAWB46A
Parts Included:
• Wind ba󰀪e (2 parts)
• 8 stainless self-tapping screws
• 4 screw covers
• This instruction sheet
Before you begin installation, read these instructions completely and carefully.
Observe all governing codes and ordinances as they may apply.
Leave these instructions with the owner.
Step 1:
Remove top screws from grille, slide the wind
ba󰀪e behind and replace the factory screws.
Step 2:
On some models, the grille screws can be used
in the same manner as the top. Use the sup-
plied screws if needed.

231-5000502 Rev. 0 04-20 GEA
Installation Instructions
Wind Ba󰀪e
Step 3:
Drive 3 screws through the front of the wind ba󰀪e where the two pieces overlap. This will
eliminate any vibration rattle during operation. Cover the ends of the screws with the supplied
caps to prevent any injury when reaching down between the ba󰀪e and the grille.