Haier GDZ5-1 User manual

HAIER
COMPACT DRYER
GDZ5-1
Training Presentation

HAIER
COMPACT DRYER
GDZ5-1
11 lbs. Electric Dryer
Stackable – Built in – Free Standing
4.13cu ft Stainless Steel Drum
Dual Temperature Operation
Dry Time Selector
“Clean Filter” Indicator Lamp
208-220v
Outdoor Venting Required

HAIER
COMPACT DRYER
GDZ5-1
WARRANTY
1st year – all parts and labor
2nd year – all parts
3rd –5
th year – drive motor, timer and
drum rust through
3rd –10
th year – cabinet rust through

HAIER
COMPACT DRYER
GDZ5-1
Stacked on top of
XQG50-QF800
Front Loading Washer
The dryer is mounted with a
locking frame attached using
the leveling legs.
Push the dryer back then lift
up to ‘unlock’ it from the
washer

Stacking Kit
Leveling Legs
are used to
mount the
stacking kit
The dryer is mounted with a
“Stacking Kit” attached using
the original leveling legs
Push the dryer back then lift
up to ‘unlock’ it from the
washer

DUCTING
Use only 4” diameter
rigid or flexible metal
duct and approved vent
hood which has a swing
out damper.
This chart shows the
maximum duct
length when elbows
are used.

CONTROL PANEL
Timed Dry Only
with a cool down period
on all settings

CONTROL PANEL
Temperature
is selected using the
Synthetic / Cotton switch
Cotton – High Heat – Button Out
Synthetic – Low Heat – Button In
The Synthetic Light will be lit when the
button is in the Synthetic setting

CONTROL PANEL
Temperature
Low Heat is automatically selected when the
Delicate setting is selected on the timer

CONTROL PANEL
Push to Start Switch
Select timer setting then
push to start the cycle
Power light will be lit

CONTROL PANEL
Clean Filter or No Heat light
(may have either designation)
This light automatically comes on in the last
8 to10 minutes of the drying cycle,
depending on the selected cycle.
This light will also be lit when the
thermostat cycles to the open position.

CONTROL PANEL
Thermostat in CLOSED position
(heat will be off– light will be OFF)
Cool down contact
in the timer

CONTROL PANEL
Thermostat in OPEN position
(heat will be off– light will be ON)
Cool down contact
in the timer

SCHEMATIC
GDZ5-1 DRYER
!! CAUTION !!
Always remove power to the circuit before
testing, troubleshooting or making repairs.

CONTROL PANEL
Removal / Service
Remove the top cover
by removing 2 vertical screws holding the cover
to the back panel
then slide the cover back
Screws
Slide back

CONTROL PANEL
Removal / Service
Slide Control Panel To Left
to release the retaining clips along the
lower edge of the control panel
Remove 2 screws
under top cover

CONTROL PANEL
Timer Removal
Timer Removal
Pull knob off from front and
remove 2 retaining screws

“WINGS” on each side must
be folded back for removal
CONTROL PANEL
Push Switch Service

Grasp the defective switch
twist and remove
Replace only the switch BODY
from the replacement
!! Service Tip !!
1
2
3
CONTROL PANEL
Push Switch Service

Indicator Lamp Removal
Pull sleeve back then slide
the lamp out of the
lens mount
CONTROL PANEL
Indicator Lamps