Hallowell 405 Wall Mount Cabinet User manual

405 Wall Mount Cabinet
ASSEMBLY INSTRUCTIONS
General Instructions
1. Check material received against the packing list. Check the number of packages received and then check the
contents of each package.
2. Check the material received for damage. If damage has occurred, secure a “damage notation” from the carrier
3. Identify each part as it is unpacked and put like parts together as close as possible to the working area where they are
to be assembled.
4. Be careful to use the correct hardware as specified in the assembly instructions.
CAUTION
In the interest of safety, all lockers must be securely anchored to the floor and/or wall. For safety, handle all components
carefully and wear work gloves when assembling lockers. Install all units plumb and tighten all hardware securely. Retain
instructions for future reference.
866-566-0500
[email protected]
www.Hallowell-List.com

2
8
5
411 10 1
3
9
12
13
405-3026/3630
15
6
7
14
LEGEND:
ww : WIDTH
hh : HEIGHT
SA1526
11-30-15
PG. 1
ITEM
NO.
PART NUMBER DESCRIPTION QTY.
1
WLS12hh-22L
WLS12hh-22R
SIDE PANEL
1
1
2 WLTBww12-22 TOP-BOTTOM 2
3 WLRwwhh-22 BACK 1
4 WLRDwwhhSV-22 DOOR 1
5 CH100 DOOR HANDLE 1
6 C100 DOOR PIN 4
7 W114 WASHER 2
8 CSS30WL
CABINET SHELF
SUPPORT
4
9 WLASww12-22 SHELF ..
10 TDS-3 DOOR STOP 2
11 WLLBhhT LOCK BAR 2
12 LRG1
LOCK ROD GUIDE
FOR DOOR
2
13 WLLDwwhhSV-22 DOOR 1
14 CS002 CHANNEL STOP 4
15 RV102
3/16 DOME HEAD
RIVET
2

STEP 1 STEP 2
Insert side panel into the bottom/top hem and slide 1.
until it bumps with the front.
2. Repeat step 1 on opposite side.
PG. 2
11-30-15
SA1526

3. Insert top/bottom part sliding it into the side panels
Make sure the
back flange fully
engages into the
side panels.
Once the Back Panel is set
press the edge of the Side
Panels to ensure full
engagement of Back Panel.
STEP 3 STEP 4
4. Insert back panel into unit. Back is snapped
in place with pressure.
PG. 3
11-30-15
SA1526

Pin
Pin
Plastic Washer
Insert Channel Stop
to all 4 corners in the
back of the unit.
Channel Stop
in place.
5. Insert pin through the top
flange of the unit. Insert door
through top pin.
PG. 4
6. Place washer between the
door and frame. Insert pin
through the inside of the
door.
Step 5
11-30-15
SA1526

DOUBLE DOOR HANDLE ASSEMBLY
HANDLE
LRG1
PIN
LOCK BAR
CAM
PLATE
RETAINER
SPLIT WASHER
SCREW
11-30-15
SA1526
PG. 5