Halotherapy Solutions HaloGX Mobile User manual

HaloGX Mobile Instructions
(It is strongly recommended that the video for this product is also viewed)
Location of equipment:
The humidity level in the room must be lower than 65%. A dehumidifier can be used to
lower the humidity in the room. If humidity is higher, salt will not rise and will stick to the
tube’s walls.
Preparing:
1.Remove the transportation bolt (see https://youtu.be/QzxpNTKkYf0I ), This bolt is only
for the protection of the halogenarator when it is being shipped.
2. Plug the transformer into the halogenerator( green light on the Stop button will light up)
Starting:
1. Remove the Fan part on top of the transparent tube by opening connection nut which is
holding fan part on top of the transparent tube).
2. Put 1 tablespoon of dry salt (you may want to warm up the salt in a crockpot first to
remove any/most moisture from the salt) into the transparent tube. (if this is for business
use this should last 1 full day of clients)
3. Fit the Fan part back on top of tube.
Now halogenerator is ready for use (There is no main on/off switch).
5. Press START . ( if halgenerator has not been used for a long tim , press start 2 times )
To see that it is working, numbers on display will blink after every second until the session
ends.
Using Turbo button:
While the non-turbo mode is best for the effects of halotherapy, many people want to
see/taste the salt, so we have created this turbo feature. Salt will blast out for 2 seconds
every 2 minutes. Press the white switch in the middle of the halogenerator front panel.
To stop the turbo function, just press it again and it will switch off.
How to change settings:
Press SET one time , green LED #1 light up
Now you can adjust session time by +/- from 1......99min 20 minutes is recommended
Press SET second time green LED #2 will light up

Now you can adjust grinding time by +/- from 1......99min 10 minutes is the recommended
grinding time (this is the final half of the 20 minute session as salt will come out for 10
minutes after the previous 2 minutes of planned stoppage)
Press SET third time green LED #3 will light up
Now you can adjust standstill time by +/- from 1......99min 2 minutes is the recommended
standstill time. Salt will not come out during this time.
Press SET fourth time green LED #4 will light up
Now you can adjust start up time by +/- from 1......99min 8 minutes is recommended. This
means that salt will come out for the fist 8 minutes before pausing for 2 minutes
Press SET fifth time green LED #5 will light up
Now you can adjust Fan speed, by +/- from 1......5min (1low...5High speed) A fan speed of 3
is recommended
Press SET sixth time , all settings will be stored.
Using with Mask/Tent
A masl can be used with this equipment and is included with the shipment. We will be
shipping a tent to you separately to keep salt particles contained. Please disconnect the
mask from the mask hose and place the hose through the tent about 3 feet high. The
halogenerator must be on the outside of the tent.
How to clean (watching video will make this much clearer):
1. Remove fan part from the transparent tube.
2. Open air pipe and mill cable.
3. Loosen fingernut , which is holding tube inside the socket.
4. Remove tube from halognerator by lifting it out.
5. Shake the rest of the salt out. If salt is stuck to tube surfaces, use a small brush to clean
up milling pipe .
(It is possible to disassemble all tube components for cleaning , details are connected by
threads.)
Never use water for cleaning . Use Slightly moisturised cloth.
Make sure, that milling area is dry.
Fill up with new salt.
Fit back all parts.