Halsey Taylor Endura II 4400BF User manual

Endura II™
Outdoor Tubular
Bottle Filling Station
Pedestal Station
Model 4400BF
This fountain is certified to
NSF/ANSI 61-Annex G, AB1953
GENERAL
Pedestal, Endura II™ Steel Outdoor Single Pedestal
Station Fountain with Bottle Filling Station with rounded
corner design, textured powder-coat finish and E-Coat
immersion for year-round beauty with minimum
maintenance. The E-coat immersion process coats the
inside and outside for the ultimate in corrosion protection.
BOTTLE FILLER
Provides a quick fill at 1 gallon per minute. Laminar flow
provides a clean fill with minimal splash and easy
maintenance.
PUSHBUTTON ACTUATION MECHANISM
Self-closing, vandal-resistant pushbutton does not require
grasping or twisting.
INLET STRAINER
Easily cleaned in-line strainer screen traps particles of 140
microns or larger before they enter the waterway.
WATER INLET & DRAIN OUTLET
Inlet: 3/8” O.D. tubing
Outlet: 1-1/2” tube outlet for 1-1/2” slip joint connection
ACCESS PANEL
Heavy-gauge steel with vandal-resistant screws. Provides
access for easy hook-up of all plumbing connections.
SUGGESTED SPECIFICATION
Unit shall include powder-coated finish with vandal-
resistant pushbutton actuation. Bottle Filler shall include a
laminar flow for minimal splash and provide 1 gallon per
minute fill rate. Shall be certified to lead-free compliance
including NSF/ANSI 61-Annex G, AB1953.
Standard Finish is Evergreen Textured
powder-coat Endura II™
halseytaylor.com
HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
10-2010
JOB NAME: ______________________
________________________________
________________________________
ENGINEER/CONTRACTOR NAME:
________________________________
APPROVAL: _____________________
DATE: __________________________
Trap and service stop not included.

Endura II™ Single Pedestal
Outdoor Tubular
Bottle Filling Station
(CONTINUED)
Model 4400BF
MOUNTING INSTRUCTIONS and
PLUMBING CONNECTIONS
Provide solid, well-drained surface to mount pedestal
fountain (concrete pad recommended). (6) ½” anchor bolts
(not included) should be attached firmly to mounting
surface in order to secure unit. (Refer to rough-in diagram)
Locate and install plumbing through ground as required.
NOTE: Unit is not furnished with service valve.
Position pedestal over plumbing and secure base to
anchor bolts. Remove access panels and connect supply
and water lines. Turn on water supply and check for leaks.
Reassemble access panels to pedestal.
Trap and service stop not included.
LEGEND:
A = 3/8” O.D. UNPLATED COPPER TUBE CONNECT
B = ACCESS PANEL (8” x 10”)
Printed in the U.S.A
TOP VIEW
OPERATING PRESSURES:
Supply water – 105 psi maximum
FRONT & SIDE VIEWS
B
B
8"
203mm
30"
762mm
64"
1626mm
44"
1118mm
14 9/16"
371mm
10"
254mm
O
3"
76mm
29 1/2"
750mm
O
SHUT OFF VALVE BY OTHERS
O1/2"
13mm (6)
O14"
356mm
O12"
305mm B.C.