Halsey Taylor 2509 User manual

97001C (Rev. A - 1/04)
2509_FTN
Halsey Taylor Owner's Manual
MODEL 2509 FOUNTAIN HEAD
1. This fountain head is to be attached to the end of a 3/8" NPT threaded pipe. The installer shall make sure the connection
pipe is properly supported for proper fountain head performance.
2. Refer to mounting specification drawing for unit size information.
3. Install shut-off valve between the building water supply and the fountain head. (Shut off valve not furnished). Utilization
of a shut-off valve simplifies future service to the fountain head.
CAUTION: This fountain is rated for inlet water pressure of 20-90 PSI. Should the inlet water supply exceed 90 PSI, a
pressure reducing regulator should be used.
4. Turn "ON" water supply and check all connections for leaks.
5. Adjust bubbler stream height. (See instructions below).
INSTALLATION
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620
PROJECTOR: If mineral deposits build up in the orifice, they can be removed by using a round file or small diameter wire.
CAUTION: Care must be taken not to damage orifice assembly.
STREAM REGULATOR: Stream height is factory set at 45-50 PSI. If supply pressure varies greatly from this, remove the
cap from the bubbler assembly/valve regulator and adjust the screw on the regulator.
Clockwise adjustment will raise stream height and counterclockwise will lower the stream height.
A stream height of 1 1/2" (38mm) is recommended (See Fig. 1)
TROUBLE SHOOTING GUIDE
FIG. 1

97001C (Rev. A - 1/04)
2509_FTN
PAGE 2
MOUNTING SPECIFICATIONS
PRINTED IN U.S.A.
IMPRESO EN LOS
E.E.U.U.
IMPRIMÉ AUX É.-U.
2222 CAMDEN COURT
OAK BROOK, IL 60523
630.574.3500
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620
ITEMIZED PARTS LIST
1
2
3
4
5
6
A54888
15011C
160118508640
160316508640
600116618640
600941818640
SCREEN
NIPPLE - 3-8
CAP - BRIGHT
PROJECTOR
STEM ASSY W/LEVER
3/8 AUTO VALVE BODY W/REG