Hamilton/Buhl HASHV4226-E User manual

(Continued on next page) Page 1
Warranty begins the date item ships from our warehouse.
All products, except metal cart, have a one year warranty
from original date of shipment, unless otherwise noted.
Metal carts have a limited lifetime warranty on all housing
components; however, carts have a one year warranty on
any electrical/mechanical components. HASHV4226-E
3.
Insert two bolts, washer and nuts (see screw table B) into each
leg of table. Washer and nut should be on the inside of leg.
Tighten all bolts and nuts.
4.
Lay unit on floor . Insert casters with brakes into opposite
corner holes in the bottom of the unit. Insert other casters into
remaining holes of unit.
1.
Insert top table section onto bottom section.
2.
Align corresponding holes of unit to obtain desired height of
table as needed.
Parts list
Qty. Description
1 Top table section with decal
1 Two shelf bottom section
1 Electrical bracket
1 Power cord
1 Rubber mat
Qty. Description
3 Screws and hex nuts (A)
9 Set Phillips head bolt, washer and hex nut (B)
2 Casters with brakes
2 Casters without brakes
Tools required:
Adjustable wrench/pliers
Rubber mallet
Screw driver
Note: This unit is easier to assemble with two people.
Screw table
Some screws may already be
screwed into related parts.
B
A
PROP 65 WARNING: This product
contains the chemical known to the
State of California to cause cancer
and birth defects or other reproductive
harm.
!
HamiltonBuhl Adjustable AV Cart
with Front Pull-Out Shelf
Model #: HASHV4226-E
Instruction Sheet

Page 2
5.
Electrical bracket assembly
A. Push power cord into back of bracket as illustrated.
B. Attach electrical bracket with power cord to any side of top
shelf with two nuts and bolts supplied (see screw table A).
Tighten nuts and bolts securely. Wrap remaining cord around
outside wings of the bracket.
7.
Pull-out shelf assembly instruction
A. Due to limited packaging space, pull-out shelf was shorten.
Adjust the pull-out shelf out to the maximum inside width of
the cart inside as the pull-out shelf will be installed inside of
the legs.
6.
Stand unit up onto casters and lay rubber mat into top shelf.
Rubber mat
B.
Align the pull out shelf to the desired height, tighten the
pull out shelf onto legs on both side as shown.
If any parts or hardware are missing or damaged, Do Not
Return the unit to your dealer. Call the HamiltonBuhl
Help Line at [phone] for immediate parts replacement.
A Division of Vcom IMC
80 Little Falls Road, Fairfield, NJ 07004, USA
1-800-631-0868 • www.HamiltonBuhl.com