Hampel's CALF-TEL CT-4030 User manual

Revised October 2021
1
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
CT-4030
Classic Access Front with Wire Side Panels
For 24|74 Calf-Tel Hutch
Assembly Instructions for Installation
CT-4030 Calf-Tel Classic Access Front with Wire Side Panels Bill of Material:
Item
Item Number
Description
Qty
1
CT-4031A
Classic Front Frame w/Gate
1
2
CT-4033
Classic Top Lock
1
3
CT-HDWE-054
Top Lock Hardware Kit
1
4
CT-4034
Classic Wire Fence, Side Panel
2
5
CT-4035
Classic Wire Fence, Side Panel Pin
2
Tools Needed:
1. ½ in Socket & Ratchet
2. ½ in Open End Wrench

Revised October 2021
2
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
Installation Instructions:
Step 1: Connect Classic Access Front Frame to
Classic Wire Fence Side Panels: Place fence side
panels on each end of Access Front Frame.
a. Starting with one fence panel, align gate and
fence to form a straight line.
b. Slide fence panel into front frame hooks.
c. Maneuver fence panel towards hutch to secure
into place.
Step 2: Secure Fence Panels: Using the provided side panel pin (2), guide pin through
fence and frame connectors.
Front Frame
Fence Panel
Front Frame
Fence Panel
Step 3: Hook top of pin
over top of fence.
Step 4: Repeat step on
other corner of fence/gate.

Revised October 2021
3
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
Step 5: Install Top Lock: Using the Top Lock and the Hardware Kit, bolt top lock to
front frame. Top lock should sit snug over the fence frame and gate opening.
Step 6: Secure Top Lock Over Frame & Gate: Once Top Lock is attached, secure over
frame & gate. Easily lift up to open gate and push down to lock gate.

Revised October 2021
4
Hampel, W194 N11551 McCormick Drive, Germantown, WI 53022
Phone: [phone] Fax:[phone]
L-rod
Assembly Instructions for Installation
Calf-Tel L-rod Bill of Material:
Item
Item Number
Description
Qty
1
CH-3332A-2
Fence L-rod
2
2
CT-9100-1
Fence Attachment Hardware
1
Tools Needed:
1. ½ in Socket & Ratchet
Installation Instructions:
Step 1: Thread on a nut, lock washer
and then the fender washer. Insert
eyebolt into hole in side of hutch.
Step 2: Large fender washer should be installed against the hutch on
the outside. Next, add a lock washer. A nut should be installed on top
of the lock washer. This helps adjust the eyebolt out to the correct
distance (approx. 1.5” to the center of the eye on the top and 1.75” to
the center of the eye on the bottom).
Step 3: Install the large fender washer against the hutch on the inside
of the hutch. Then, add a lock washer and secure in place with a nut.
This helps tighten the eyebolt in place once the desired location is
established on the outside.
Step 4: Fence is locked into position when the upper eyebolt and the
lower eyebolt are within one section on the fence. This keeps the fence
from moving forward and backward.