Hans Grohe Starck Parts list manual

Installation Intructions / Warranty
Starck
10976XX1
Steel
35976801
Phoenix
17955XX1
Phoenix
17954XX1 Massaud
18976001
Uno
38976XX1
VOLUME CONTROL VALVE ½" AND ¾"
Trim sets
Rough-in Ref. No.: 13974181 / 13975181

2
10
5
5.1
1
4
2
3
9
6
6.1
Starck
10976XX1
Steel
35976801
Phoenix
17955XX1
Phoenix
17954XX1
Uno
38976XX1 2
6.1
8
7
14
11
12
13
Massaud
18976001

3
1 sleeve Starck / Steel 92650XX0
2 sleeve Uno 97512XX1
3 sleeve Phoenix 92654XX0
4 escutcheon Starck / Steel / Uno / Phoenix 94353XX0
5 handle Starck 10993XX1
5.1 screw-cover Starck 96540XX1
6 handle Steel 35993801
6.1 screw-cover Steel / Uno 96541001
7 handle Massaud 18096001
8 handle Uno 38993XX1
9 lever handle Phoenix 96630XX1
10 cross handle Phoenix 96794XX1
cross handle Phoenix 96794811
11 sleeve Massaud 98835000
12 escutcheon Massaud 98676000
13 fixing set Massaud 96392000
14 nut Massaud 98677000
Extension Set (If needed, please order separately)
Extension set 1" Starck / Uno / Phoenix / Steel 13978000
Extension set 1" Massaud 96370000
Spare parts
XX = Color code:
Starck / Uno - 00 chrome
- 82 brushed nickel
Phoenix - 00 chrome
- 62 oil rubbed bronze
- 82 brushed nickel
Steel - 80 steel®
Massaud - 00 chrome

4
Assembly Starck / Steel / Uno / Phoenix
1
2
3
17954XX1/17955XX1 Phoenix
Sleeve and escutcheon assembly
1. Remove the cover
2. Seal around the rough-in with waterproof ba-
throom sealant
Install the trim sleeve
Install the escutcheon.

5
4b
4c
35976801 Steel /
38976XX1 Uno
1. Lock the screw by hand only three turns.
2. Snap on the handle.
3. Fix the screw.
4. Cover the hole by the plastic cap.
17954XX1 / 17955XX1 Phoenix
4a Handle assembly
10976XX1 Starck
1. Push the handle onto the shaft.
2. Fix the screw.
3. Cover the hole by the plastic cap.
Assembly Starck / Steel / Uno / Phoenix

6
Assembly Massaud
2
1
3
1. Seal the wall around the plaster shield with
waterproof bathroom sealant.
2. Install the slip coupling on the valve.
1. Mark a point on the slip coupling 1/2” from the
surface of the finished wall. Cut the slip coupling
at that point.
2. Install the spindle extension on the valve.
Cut the plaster shields so that they extend 1/16”
outside the surface of the finished wall.

7
Assembly Massaud
4
6
5
Mark a point on the spindle extension 13/16” from
the surface of the finished wall. Cut the spindle
extension at that point.
Install the sealing ring, escutcheon, sleeve and
nut.
Install the snap connector and screw.
Place the handle over the snap connector and press
very firmly into place. Fix the hollow set screw with
a hex wrench 1,5 mm.

8
Starck
10976XX1
Steel
35976801
Phoenix
17955XX1
Phoenix
17954XX1
Uno
38976XX1
Massaud
18976001

9
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the
market with regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment
is not covered under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturer’s instructions when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause
considerable damage to finishes and to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale
buildup and water spotting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than
necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the
product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after
use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.
Cleaning Recommendation for Hansgrohe Products

10
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc.
(„Hansgrohe“). This warranty is limited to Hansgrohe products which are purchased by a consumer in the
United States after March 1, 1996, and installed in either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product
against defects in material or workmanship as follows: Hansgrohe will repair at no charge for parts only
or, at its option, replace any product or part of the product which proves defective because of improper
workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is
unable to provide a replacement and repair is not practical or cannot be timely made, Hansgrohe may
elect to refund the purchase price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the
following two sentences. If you are a consumer who purchased the product for use primarily for personal,
family, or household purposes, this warranty extends for as long as you own the product and the home
in which the product is installed. If you purchased the product for use primarily for any other purpose,
including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect
to Interaktiv and Retroaktiv products, and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo
products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance,
misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents
or „no rinse“ cleaning products, or the use of the product in any manner contrary to the product
instructions.
C. Labor or other expenses for the disconnection or return of the product for warranty service, or for
installation or reinstallation of the product.
D. Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Or, call Hansgrohe toll-free at [phone].
Limited Lifetime Consumer Warranty