Hanwha Techwin PNV-A9081RLP User manual

LPR/ANPR Cameras
QUICK REFERENCE GUIDE
PRE-INSTALLATION
CONFIGURING
YOUR CAMERA
1
3
2INSTALLING AND
POSITIONING CAMERA
LPN HT-777-WS
Model HT230C
Type SUV
Brand HTV
Color RED

CONTENTS
1PRE-INSTALLATION
1.1 Choosing a Location
3CONFIGURING YOUR CAMERA
3.1 Field of View
3.2 Congure Initial Camera Settings
3.3 Simple Focus on Plate Read Area
3.4 To measure pixel width of license/number plate
3.5 Observing Proper Installation
3.6 Examples of Improper Install
2INSTALLING AND
POSITIONING CAMERA
2.1 Camera Installation
2.2 Adjust for Plate “Rotation” Angle
2.3 LPR(ANPR)/ MMCR Specication

3 | LPR/ANPR Cameras Quick Reference Guide
1PRE-INSTALLATION
1.1 Choosing a Location
The LPR (License Plate Recognition)/ ANPR (Automatic Number Plate Recognition) Technology running on this camera will
provide you with the best results when following the recommended installation constraints below.
30º
Minimum Forward Distance
Maximum Vertical Angle
Maximum Forward Distance
30º
8 m
20 m
5 m
Recommended
30 degrees Maximum Vertical Angle
Maximum Forward Distance depends on
lens zoom, however should not exceed
20m / 65.6 ft considering eective IR
range (for PNO and PNV models).
Please consider using external IR for
ranges above 20 m / 65.6 ft.
Fig. 1
Camera shown from side
Fig. 2
Example of installation at a height of 5 m

4 | LPR/ANPR Cameras Quick Reference Guide
1.1 (Continued)
FORWARD DISTANCE TABLES
The orange dots on the tables below are recommended installation measurements.
Forward Distance (m)
6
(19.6’)
8
(26.2’)
10
(32.8’)
12
(39.3’)
14
(45.9’)
18
(59.0’)
19
(62.3’)
20
(65.6’)
5(16.4’) •••••••
6(19.6’) ••••••
7(22.9’) ••••
8(26.2’) • •
Camera Height (m)
[PNO/PNV-A9081RLP]
* Day and night conditions with built in IR
* PNB-A9001LP parameters depends on lens & external IR.

5 | LPR/ANPR Cameras Quick Reference Guide
1.1 (Continued)
All the license Plate that are meeting the pixel criteria as below
will be recognized in the selected area.
• 130-300 pixels for regular EU plates
• 80-300 pixels for US plates without stacked symbols (small
ones)
• 160-300 pixels for US plates with stacked symbols
30ºMaximum Horizontal Angle
Minimum Forward Distance
Maximum Forward Distance
Recommended
30 degrees Maximum Horizontal Angle
Fig. 3
Camera shown from top
Fig. 4
Camera in 4K mode can cover up to 3 road lanes.
The FullHD mode can cover up to 2 lanes.
Normally, setting recognition zone (see orange frame
below) in lower half of camera view is sucient and
favours app performance.
Best results are achieved when single row number
plate width has t the criteria. Greater width may aect
performance.

6 | LPR/ANPR Cameras Quick Reference Guide
2INSTALLING AND POSITIONING CAMERA
2.1 Camera Installation
NOTE: Refer to PNO-A9081RLP, PNV-A9081RLP or PNB-A9001LP installation guide and follow the installation instructions.
2.2 Adjust for Plate “Rotation” Angle
For best results, check the angle of your plate compared to the horizontal angle and rotate
the camera to less than 5° as shown below (Recommended Angle(s).
>5°
Recommended Angle(s)
5°max

7 | LPR/ANPR Cameras Quick Reference Guide
2.3 LPR(ANPR)/ MMCR Specication
LPRANPR CAMERAS PNVA9081RLP PNOA9081RLP PNBA9001LP
Solution Community Traffic Observation / Parking Application City Traffic Observation Highways
Speed Description Moderate Speed Low speed Regular Speed High Speed
Lane Coverage Up to 2 lanes Up to 3 lanes Up to 2 lanes Up to 2 lanes
Speed limit Up to 70kmh (45mph) Up to 40kmh (25mph) Up to 100kmh (65mph) Up to 140kmh (90mph)
Min. Forward Distance 12m (38ft) 10m (33ft) 16m (52ft) 27m (90ft)
Max. Forward Distance 17m (55ft) 16m (52ft) 46m (150ft) 46m (150ft)
Max. Horizontal Angle 25° 30° 25° 15°
Max. Vertical Angle 25° 30° 25° 15°
Horizontal Offset Up to 5m (18ft) Up to 7m (24ft) Up to 7m (24ft) Up to 4m (12ft)
Camera Height Up to 5m (18ft) Up to 7m (24ft) Up to 7m (24ft) Up to 7m (24ft)
Vehicle Recognition
Make : 70+ Makes
Model : 600+ models
Color : 10 colors
Make : 70+ Makes
Model : 600+ models
Color : 10 colors
Make : 70+ Makes
Model : 600+ models
Color : 10 colors
Make : 70+ Makes
Model : 600+ models
Color : 10 colors

8 | LPR/ANPR Cameras Quick Reference Guide
3CONFIGURING YOUR CAMERA
NOTE: There is no default user name and password to access the camera setting, 1) Please make your own user name and password at the
rst instance when you access the camera settings.
2) Make sure to set correct date and time for the camera before going in to any additional settings.
3.1 Field of View
The below steps you will perform in the Wisenet camera conguration webpage
1Congure camera so left and right are correct, not mirrored.
2Set camera zoom to capture license plate
3Adjust camera view angle so plate passes through the middle of the image.
3.2 Congure Initial Camera Settings
For proper operations, please, check and set properly:
• Camera Date Time (+page 9)
• IP settings (+page 10)
• SD card storage (+page 12)
• Camera exposure and focus (+pages 13~14)
SSDR, WDR, DIS, Defog, AGC and anti-ickering features are good for human eye but aect computer vision performance
and therefore setting these to the least possible eect or turning o strongly advised.

9 | LPR/ANPR Cameras Quick Reference Guide
3.2 (Continued)
[Date and Time]
Choose ATimezone and set Use daylight
saving time as appropriate.
Set Bdate and time or opt to synchronize
with your PC or NTP server.
NOTE: Wisenet Road AI app relies on these
settings and if these are not set properly you
may not see events in Wisenet Road AI app and
events delivered to the outer systems may not
contain proper timestamps.
Date & Time
A
B

10 | LPR/ANPR Cameras Quick Reference Guide
3.2 (Continued)
[IP, DNS, Ports]
Proper IP, DNS and ports setting are
important for:
• NVR and other integrations
• outside LAN access if required
NOTE: Reboot the camera whenever IP address
gets changed.
IP & Port

11 | LPR/ANPR Cameras Quick Reference Guide
3.2 (Continued)
[Go to App]
Please go to App in camera open platform section.
To run the Wisenet RoadAI app, select the
Open platform menu and click the A
GoApp button in the Application name
eld.
Open platform
A

12 | LPR/ANPR Cameras Quick Reference Guide
3.2 (Continued)
[microSD card]
Your camera is supplied with micro SD card.
SD-card is managed by the Wisenet RoadAI
application and no user interaction needed.
Please check the BSD-Card status in the A
ABOUT section of the Wisenet RoadAI app.
Change the micro SD card if you see Error
status
A
B

13 | LPR/ANPR Cameras Quick Reference Guide
3.2 (Continued)
[Exposure adjustments]
Use the recommended settings from the Wisenet Road AI application in most cases. But if you need to manually adjust
here are the most common settings that affect the LPR performance.
ASensor: 25-30 fps
BSSDR: O
CWhite balance: ATW
DBack light: O
(try other backlight options only if camera gets blind-
ed by headlights in the night)
EExposure:
• minimum shutter speed : 1/300
• maximum shutter speed : 1/700
• preferred shutter speed : 1/500
• Anti icker : O
• SSNR : Default
• AGC : Low
FDay/Night:
• Mode: Auto
GIR: manual
HOther settings: default
Camera setup
A
B C D E F
G
H

14 | LPR/ANPR Cameras Quick Reference Guide
AGC o, BW, IR on
AGC low, Color, IR on
3.2 (Continued)
[Exposure adjustments-Automatic Gain Control]
Automatic Gain Control can improve overall scene visibility
notably. However, even at low setting AGC produces noise that
can ruin license plate images, also lighter areas tend to bleach out.
See illustrations to the left.
Start with turning AGC o. See the illustration to the left. Set AGC
to low to improve plates visibility unless only other methods are
helpful.
Adjust zoom so that real plate pixel width is at least 130px.
Consider adjusting recognition zone so it is closer to the centre of
the frame to avoid IR vignette eect.
NOTE: Do not use WDR as it decrease the shutter speed and may blur
the vehicles.
AGC low, BW, IR on

15 | LPR/ANPR Cameras Quick Reference Guide
NOTE:
The focus setting of PNB-A9001LP is related to the
lens type, and manual focus is activated when using a
manual varifocal lens.
The area indicated is not stored. If you need to perform a
new Simple Focus, please draw a new area on-screen.
Set the focus to have plates in the proper pixel size.
• 130-300 pixels for regular EU plates
• 80-300 pixels for US plates without stacked symbols
(small ones)
• 160-300 pixels for US plates with stacked symbols
3.3 Simple Focus on Plate Read Area
A unique feature of this camera allows you to select the plate area and hit a button to perform a “Simple Focus”on
this plate area.
1From the Video & Audio menu, select Focus setup.
2
Click and drag to draw an area of focus where the
license plate is displayed.
3Click the Simple Focus button to initiate a focus
operation on the user-specied area.
Focus setup
1
2

16 | LPR/ANPR Cameras Quick Reference Guide
3.4 To measure pixel width of license/number plate
1
Spread or move license/number plate (cars) across the scene (see illustration on the left below) and take snapshots using
web viewer capturing feature (Live ;Capture);
1
1

17 | LPR/ANPR Cameras Quick Reference Guide
3.4 (Continued)
2Use Plate Grid tool in the Settings tab of WisenetRoadAI and Freeze Frame feature to check whether plate ts the
allowed range.
3You can add an image from the Wisenet Road AI ;Settings ;Freeze frame to show the actual settings.
3
3

18 | LPR/ANPR Cameras Quick Reference Guide
3.5 Observing PROPER Installation
SCENE REQUIREMENTS:
• good proportion to the frame width
• well lit
• sucient contrast
• acceptable tilt angle
• good proportion to the frame width
• perfect IR power
• sucient contrast
• critical yet acceptable tilt angle
Fig. 1
Daytime
Fig. 2
Night time
HAN 0123
> 130px
HAN 0123
<30˚ <30˚
<5˚
<5˚
HAN 0123
License/number plate is
more than 130px in width
License/number
plate is readable
Vertical angle is less
than 30°
Horizontal angle is
less than 30°
Tilt angle is less
than 5°

19 | LPR/ANPR Cameras Quick Reference Guide
3.5 (Continued)
POSSIBLE IR RESTRICTIONS:
The license/number plate is quite close to the frame boundary.
You may notice a vignette eect.
The license/number plate is closer to the centre of the frame.
The plate is lit much better.
Pay special attention to IR vignette eect (see illustration on the left) when setting up recognition zone. The closer to the center
the more even lighting is.
Also in this particular case real pixel width of the license/number plate is critically small.
The Automatic Gain Control eect will be illustrated in camera exposure settings section.

20 | LPR/ANPR Cameras Quick Reference Guide
3.6 Examples of IMPROPER Installation
Depth of eld is insucient to
cover foreground license plates.
Adjust the lens settings.
Improper focus settings.
Adjust the lens.
Blurry image due to long exposure.
Fix the shutter speed to obtain
sharper picture.
Focus and Shutter faults
Too small (less than 130px wide)
Tilt angle exceeds 5°