Happy Trails HTP1-8-30 User manual

If installing the light mount with a headlight guard,
check the thickness of the tabs on either side of the
headlight prior to removing the bolt. If the tab is thick
as shown in the rst photo, use the M860S bolt. If the
tab is thin as shown in the 2nd photo, use the M850S
bolt. If installing the light bracket without a headlight
guard, install it with the M850S bolt.
Remove the bolt from the headlight mount as shown in
Fig 2.
Place an M8 Lock Washer on the M8 bolt. Slide the
“top” hole on the light mount over the bolt. Place a 3/4”
x 3/4” x .319” black spacer over the bolt. Begin thread-
ing the bolt back into the headlight mount.
Fig 1
Fig 2
Fig 3
Step 1
Step 2
Step 3
HTP1-8-30 BMW F650(Twin)/700/800GS Light Bracket
ank you for purchasing Happy Trails products. Our products are proudly hand made in Boise
Idaho, USA. If you have any questions or concerns about the installation of this product, please con-
tact us directly at 1-800-444-8770 or e-mail [e-mail].
Before you begin, place the bike on a hard level surface where you have room to work. Lay out the
parts included in this kit and compare to the parts list on the nal of these instructions. If any parts
or hardware are missing, contact us immediately at the number or email listed above.

4/4/13
Rev. 2
HH
Recommended Tools:
6mm Allen Wrench
Hardware List:
2 - M860S bolts
2 - M850S bolts
2 - M8 Lock Washers
2 - M820C bolts
2 - M8N nuts
4 - 8mm Flat Washers
Tighten the bolt to 18 /lbs with the light tab facing
downward as shown. We recommend placing the lower
hole which is to be used at the front of the mount. e
larger hole is for 10mm studs on PIAA lights, while the
smaller hole should work for the 8mm studs on lights
from other manufacturers.
Fig 4Step 4
Mounting hardware has been included for lights that
do not come equipped with their own mounting hard-
ware. To install the auxiliary light, place the bolt into
the mounting hole in the light then through the appro-
priately sized mounting hole then tighten the included
Nylock nut into place.
Fig 5Step 5