SRC R-HM18-04-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: R-HM18-04-01-AL / R-HM18-04-02-AL
Part Description: Rack –Royal Enfield Himalayan
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1:
Top Rack can be partially off-line, before being
brought up for Installation/Mounting it to the
Rack carrier
Slide in the Taper Ring (2) –3 off to and Screws
M8 x 25 (4) –3 off as per the Scope and Bill of
Materials, in the 3 mounting holes as shown in
the drawing
Mounting Installation

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 2:
Position the Mounting Brackets (3) –3 off, as shown in the
drawing, form the downside of the Rack Carrier and align the
holes to the Screws that pop out of the Top Rack and secure
the threads using the M8 Nuts (5) –3 off.
Once secured and positioned, tighten the nuts, to torque as
indicated in the BOM table

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it will
be explicitly specified in the instruction sheets.