Hardinge 16C User manual

MOUNTING INSTRUCTIONS
and
PARTS LIST
for
16C DEAD LENGTHWORK STOP
The dead length work stop makes it possible to accurately locate and hold parts that have a
previouslymachinedshoulder. The soft, machineablestop platescan be boredinyour shop tothe
appropriate size for nearly instantaneoususe. The work stop can be mounted on any Hardinge
machinethat has a
A2-5 spindle.
Mounting Instructions:
1. Bore stop plate "C", Figure 1 to the desired
diameter that will provide clearance for the
partto be gripped. This may be done on a
separatemachine.
2. Installthe correct size collet (separateitem)
inthe spindle and adjust the gripping pres-
sure as outlined in the operator's manual
suppliedwith the machine.
3. Use a clean shop rag to wipe off the front
face, mounting taper, and shoulder of the
spindle; the backface and I.D. of work stop
mount
"A"; and bothfaces of stop plate"C".
4. Install work stop mount "A" on the spindle
usingfour screws
"DM.
5. Place stop plate "C" in the mount with the
taperedsidefacingoutas showninFigure
1.
6. Holdthe stop plate against the spindle face
and snug down four set screws
"B". Do not
over tighten.
- NOTE =
MACHINE
SPINDLE
- COLLET
D
Figure 1 - Dead LengthWork Stop
After the job is completed, the stop plate can be removed and etched with the job
number (not onthe locatingfaces) andstored for future use.
Hardinge Brothers, Inc.
Elmira, New York 14902-1507
Telephone: [phone] @Fax: [phone]
Form No. B-59
Part No. B -0009500-0059 Litho
in U.S.A.
August, 1991

PARTS LIST
16C COLLET
(SEPARATE ITEM)
ITEM PART NUMBER QUANTITY DESCRIPTION
Stop MountAssembly
(Includes Items
I, 2, and 4)
Work Stop Mount
10-32 x 318 Set Screw
Work Stop (Set of
3)
7/16-14
x 1 Skt. Hd. Cap Screw
O 1991 HardingeBrothers, Inc.