HARLINGEN 1 Ton User manual

Arbor Press
WWW.HARLINGENTOOLS.COM
Please read this instruction carefully before using. You should be in
accordance with the located safety rules besides the above instructions.

Harlingen arbor press is designed for variety of using functions like
riveting, squeezing, bending etc. Presses are suited for work in production
lines as well as in machine shops, automotive repair shops and home
workshops.
Summary
Basic Parameters
01
1. Mount arbor press to bench or stand. Secure arbor press using two
mounting holes on the body.
2. Insert handle into pinion and replace cap and bolt. Secure handle in
position with knob.
3. To use with a punch, remove pinion retaining ring and set screw from
pinion. Remove pinion from the body. Remove ram, mount ram upside
down so the punch hole is facing down. Replace pinion, pinion retaining
ring and set screw. Insert the punch best suited to the job. Magnet inside
ram will secure punch in position. Set screws will ease or restrict the ram
action. Adjust to your requirements.
Operation
mm
Model
1 Ton
2 Ton
3 Ton
Base Length (A)
270
430
455
Base Width (B)
130
170
205
Height (C)
285
395
545
Max. Work Height (D)
100
170
260
Swing (2E)
197
272
308
Anvil Dia. (F)
120
165
190
Ram Dia. (G)
25×25
32×32
38×38

Maintenance
2. If the ram is loose and drops by itself, loosen hex nuts and tighten
screws for adjustment. All screws should be tightened with the same
amount of pressure. Secure set screws by tightening nuts.
1. Oil the pinion periodically through the oil fitting, and grease the ram rack
whenever necessary. Keep a light film of oil on machined surface to
prevent rust. Keep work area clean. Clean the arbor press of dirt and
debris after every use.
02
1.Ram
2. Plate
3. Plate
4. Grub screw
5. Screw
6. Hexagon screw
7. Casting
8. Cylindrical pin
9. Position plate
10. Knob
11. Grub screw
12. Steel ball
13. Springe
14. Pinion
15. Lever rod