Harrod NBL-032 User manual

NBL-032
Floor Fixed Netball
INS146
09/02/10
Revision 3
Harrod UK Limited©
Fig 1
8910
View of Product
1. 2 x Floor Fixed Netball Upright (PEQ609)
2. 2 x Floor Fixed Netball Base (PEQ600)
3. 2 x International Netball Ring (PEQ629)
4. 8 x Standard SH2 Ground Sockets for
Solid Floor (ASY001+BOL855)
4. 8 x Long SH2 Ground Sockets for
Sprung Floors (ASY002+BOL855)
5. 8 x M12 x 30 Button Head Screw (BOL142)
6. 4 x M10x25 Square headed Bolt (BOL336)
7. 4 x M10 Nylock Nut (BOL202)
8. 4 x M10x50 Stainless Steel Hex Screw (BOL306)
9. 4 x M10 Washer (BOL709)
10. 4 x M10 Plastic Washer (BOL721)
11. 8 x Large M12 Washer (BOL702)
12. 1 x 8mm Allen Key (BOL790)
13. 4 x M10 Spring Washer (BOL713)
(Optional)
(Optional)
Socket Installation Dimensions
Please read instructions before you
begin to assemble your netball
posts. The pack contents are for a
pair of posts.
260mm
260mm
6711
4
512
Code:
Product:
Pack Contents
Fig 2
1
2
3
Side Line
13
8
13
9
5
11
4

NBL-032
Floor Fixed Netball
SH2 Socket Installation:
The sockets should be installed by a specialist, using the following guidelines, place
contact your distributor for recommended specialist fitting engineers.
Mark at location shown in Fig 2. Drill 20 hole 160mm deep from finished floor level for
standard SH2 socket or 210mm deep for longer SH2 socket (purchased separately for
sprung floor).
Ø
Fig 3
7
10 6
1Using the pack contents list overleaf, identify the parts required to assemble the
Netball Posts purchased.
2Using the M12 Button Head Socket Screws bolts provided anchor the base of the
netball posts to the ground (Fig 1), secure with the 8mmAllen Key provided.
4Insert the posts over the base spigot ensuring that the recess of the aluminium post is
inside the court. Secure with bolt (8) and washers (9 & 13).
3Slide 2 M10x25 bolts (6) up the recess of the aluminium extrusion. Offer the netball
ring up to the recess in the post locating the bolts through the plate, ensure that the top
of the plate in the ring is flush with the top of the post and secure with M10 Nyloc (7) and
Washer (10) (Fig 3).
Code:
Product:
Assembly Instructions