Harrod VOL-046 User manual

4
3
5
1
VOL-046/047
Floor Fixed Volleyball Posts
INS046
24/11/2015
Revision 2
Harrod UK Limited©
400mm
11m Centres
Socket Installation Dimensions
Net Not Included
Fig 2
Please read instructions before you begin to assemble your volleyball posts.
Code:
Product:
Pack Contents:
Pack Contents
VOL-046
1. 1 x Floor Fixed VB1 Volleyball Base (Pair) (FEP033)
2. 1 x VB1 Upright (Pair) (FEQ920)
(ITEMS BELOW ARE PACKED IN BASES WITHIN FPK046)
3. 4 x M12x30mm Button Head Socket Screw (BOL142)
4. 4 x Large Washer (BOL702)
VOL-047
5. 1 x Floor Fixed VB1 Volleyball Base (Pair) (FEP032)
6. 1 x VB4 Upright (Pair) (FEQ930)
(ITEMS BELOW ARE PACKED WITHIN FPK046)
3. 4 x M12x30mm Button Head Socket Screw (BOL142)
4. 4 x Large Washer (BOL702)
Optional Extras
7. 4 x Standard SH2 Ground Sockets For Solid Floors (ASY001+BOL855)
8. 4 x Long SH2 Ground Sockets For Sprung Floors (ASY002+BOL855)
Fig 1
26
6
2
1
5
4
3

VOL-046/047
Floor Fixed Volleyball Posts
1Using the pack contents list overleaf, identify the parts required to assemble
the volleyball Posts purchased.
2Using the M12 Button Head Screw (3) and Washer (4), anchor the base of
the volleyball posts to the ground securing with anAllen Key.
3Insert the post into the spigot on the base push the button clip in and locate in
the hole on the spigot until the clip engages and fully emerges through.
; upright is universal, spring clip may need relocating in opposite
side of upright in order to orientate the upright correctly in the base.
Please note
SH2 Socket Installation (Optional Extra):
The sockets should be installed by a specialist, using the following guidelines,
please contact your distributor for recommended specialist fitting engineers.
Mark at location shown in Fig 2. Drill 20mm holes 160mm deep from floor
level for standard SH2 sockets for solid floors or 210mm deep for longer SH2
socket for sprung floors.
Ø
Code:
Product:
Assembly Instructions
Post Assembly