HART VOC812SW 3701 User manual

VOC812SW 3701
8 Gallon Wet/Dry Vacuum
Aspirateur Eau Et Poussière 8 Gallons
Aspiradora Para Mojado/Seco De 8 Galones
OPERATOR’S MANUAL
Safety Information 2-3
Symbols 4
Features 4
Assembly 4-7
Operation 8-11
Maintenance 12-14
Troubleshooting 14
Warranty 15
Exploded View 16
Parts List 17
 Parts/Service
Back Page
THIS INSTRUCTION BOOKLET CONTAINS
IMPORTANT SAFETY INFORMATION. PLEASE
READ AND KEEP FOR FUTURE REFERENCE.
WARNING: To reduce the risk of
injury, the user must read and understand the
operator’s manual before using this product.
LE PRÉSENT LIVRET D’INSTRUCTIONS CON-
TIENT DES CONSIGNES DE SÉCURITÉ IMPOR-
TANTES. VEUILLEZ LE LIRE ATTENTIVEMENT
ET LE CONSERVER AFIN DE POUVOIR VOUS
Y RÉFÉRER ULTÉRIEUREMENT.
AVERTISSEMENT: Afin de
réduire tous risques de blessures, l’utilisateur
doit lire et assimiler le contenu du manuel
d’utilisation avant de se servir de ce produit.
ESTE MANUAL DE INSTRUCCIONES CONTIENE
IMPORTANTE INFORMACIÓN DE SEGURIDAD.
POR FAVOR LEA Y CONSERVE PARA REFER-
ENCIA FUTURA.
ADVERTENCIA: Para reducir
el riesgo de lesiones, el usuario debe leer y
comprender el manual del operador antes de
usar este producto.
MANUEL D’UTILISATION
Consignes de sécurité 1-2
Symboles 3
Caractéristiques 3
Assemblage 3-6
Fonctionnement 7-10
Entretien 11-13
Dépannage 13
Garantie 14
Vue Éclatée 15
Liste Des Pièces 16
 Pièces/Réparations
Dernière Page
MANUAL DEL OPERADOR
Información de seguridad 1-2
Símbolos 3
Características 3
Armado 3-6
Funcionamiento 7-10
Mantenimiento 11-13
 ResoluciónDeProblemas 13
Garantía 14
Vista En Detalle 15
Lista De Piezas 16
 PartesyServicio
Páginas Posteriores

6
ATTACHING THE REAR WHEELS & CASTERS
See Figures 7 and 8.
•Turnthecollectiontankupsidedown.Insertthetwocaster
feet into the slots on the front of the collection tank and
tightenwithsuppliedscrews.Therearwheelsandthe
vacuumbasearemarkedwiththenumbers1and2.Insert
wheel1intoslot1onthebackofthevacuumandtighten
withsuppliedscrew.Insertwheel2intoslot2ontheback
of the vacuum and tighten with supplied screw. Verify
that the rear wheels and casters are mounted correctly
asshown.Donotover-tightenscrews.
ATTACHING THE HANDLE
See Figure 9.
•
Attach the handle into the slots located on the top of the
powerheadandsecurewithsuppliedscrews.
INSTALLING THE PULL/PUSH HANDLE
See Figure 10.
•Insert the pull/push handle into the handle sockets
mountedonthesidesofthecollectiontank.Pushdown
untilthelockpinsclickintoplace.
INSTALLING THE CARTRIDGE FILTER
See Figures 11 and 12.
•Yourvacuumcomesreadyfordryvacuumcleaning.If
the cartridge filter is not installed, refer to page 13 for
installationinstructions.
INSTALLING THE DUST COLLECTION BAG
See Figure 13.
•Optional: For improved dust filtration, fit the dust bag
flange onto the inlet port, taking care not to damage the
bag.
ASSEMBLY
FIG. 7
FIG. 8
FIG. 9
FIG.10
FIG.11
FIG.12
FIG.13
REAR WHEEL
CASTER
DUST BAG
CARTRIDGE
FILTER
PULL/PUSH
HANDLE

7
INSTALLING THE FOAM WET FILTER
See Figure 14.
•Forwetvacuumcleaning,removethecartridgefilter,and
installthesuppliedfoamwetfilter.Seepage13 for the
foamwetfilterinstallationinstructions.
ATTACHING THE POWER HEAD
See Figure 15.
•Place the power head back on the collection tank aligning
thetopsectionwiththelatches,andsnapintoplace.
ATTACHING THE HOSE
See Figure 16.
•Insertthelockingendofthehoseintothevacuumport
onthecollectiontankandlockintoplace.
ASSEMBLY
FIG.14
FIG.15
FIG.16
HOSE
POWER HEAD
INSTALLING & REMOVING ATTACHMENTS
See Figures 17 and 18.
•Theseattachmentslocktogether to preventthemfrom
detachingduring use. Connectthedesiredattachment
onto the end of the hose or extension wand by aligning
thetabsandpushtogetheruntiltheylockintoplace.
•Toremovetheattachment,pressdownonthelockingtab
andslideitoff.
FOAM WET
FILTER FIG.17
FIG.18
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a
polarizedplug(onebladewiderthantheother).Thisplug
willfitinapolarizedoutletonlyoneway.Iftheplugdoesnot
fitfullyintheoutlet,reversetheplug.Ifitstilldoesnotfit,
contactaqualifiedelectriciantoinstalltheproperoutlet.Do
notchangethepluginanyway.Doubleinsulation
eliminates the need for the three wire grounded power cord
andgroundedpowersupplysystem.

11
FIG.39
FIG.40
FIG.36
FIG.37
FIG.38
OPERATION
FIG.34
FIG.35

13
MAINTENANCE
INSTALLING CARTRIDGE FILTER
See Figures 46-48.
•Verifythatthepowercordisdisconnectedfromtheoutlet.
•Removethepowerheadandplaceinanupsidedown
position.
•Installthecartridgefilteroverthefiltercagemakingsure
thecageiscompletelycovered.
•Place the filter retainer on the top of the cartridge filter
overtheraisedlipandtightendownbyturningtheretainer
clockwise;donotover-tighten.
•Placethepowerheadbackontothecollectiontank.
REMOVING & CLEANING CARTRIDGE FILTER
See Figure 49.
•Unlockandremovethefilterretainerbyturningtheretainer
handlecounterclockwise.
•Withtheremovedpowerheadinanupsidedownposition,
carefullyremovethecartridgefilterfromthefiltercage.
•Clean the cartridge filter by gently tapping or brushing dirt
off.Cleaningshouldnotbedoneindoorsinlivingareas.
Foroptimalperformanceanewfilterisrecommended.
•Install cleaned or new filters as above in steps 2-4 of
InstallingCartridgeFilter.
•Wetfiltersshouldberemovedandallowedtoairdryfor
24hoursbeforeinstallingontothefiltercage.
INSTALLING FOAM WET FILTER
See Figures 50-51.
•Verifythatthepowercordisdisconnectedfromtheoutlet.
•Removethepowerheadandplaceinanupsidedown
position.Followinstructionstoremovethecartridgefilter
onpage13.
•Carefullyslidethefoamwetfilterdownoverthefiltercage
makingsurethecageiscompletelycovered.
•Placethepowerheadontothecollectiontank.
FIG.46
FIG.49
FIG.47
FIG.50
FIG.48
FIG.51

15
WARRANTY
Wetakeprideinproducingahighquality,durableproduct.ThisHARTTMproductcarriesalimitedthree(3)yearwarranty
againstdefectsinworkmanshipandmaterialsfromdateofpurchaseundernormalhouseholduse.Ifproductistobeused
forcommercial,industrial,orrentaluse,a90daylimitedwarrantywillapply.Pleasekeepyourreceiptasproofofpurchase.
Thiswarrantygivesyouspecificlegalrights,andyoumayhaveotherrights,whichvaryfromstatetostate.Forproduct
servicecallCustomerServiceat1-866-384-8432.
NotCoveredbyWarranty:
•Anypartthathasbecomeinoperativeduetomisuse,negligence,direct/indirectabuse,accidents,impropermaintenance,
repairs, or alterations;
•Consumables such as filters and accessories;
•Normalwearandtearofpartsandattachments,suchashose,nozzles,orcasters;
•Normaldeteriorationoftheexteriorfinishduetouseorexposure;
•Anyproductwhereserialnumber/datalabelistamperedwithorremoved;
•Anyproductpurchasedfromanunauthorizedretailer.

16
EXPLODED VIEW
1
2
3
4
5
5
19
20
21
22
23
25
24
26
6
6
7
8
9
10
11
12
13 13
14
15
16
17
18

17
PARTS LIST
PART PART NUMBER DESCRIPTION QUANTITY
1 551058101 Handle Assembly 1
2 Power Head Assembly 1
3 551416106 Float 1
4 551437105 Filter Cage 1
5 551259109 Pull/Push Handle Socket 2
6 551152109 Latch Assembly 2
7 Collection Tank 1
8 551016105 Vacuum Port 1
9 551271102 Drain Assembly 1
10 551436104 Drain Cap 1
11 551150104 Vacuum Base 1
12 551059110 Rear Wheel 2 1
13 551437103 Caster Foot Assembly 2
14 551059108 Rear Wheel 1 1
15 551086112 Cord Hook 1
16 551021121 Grounding Chain 1
17 551437107 Filter Retainer 1
18 551030114 Cartridge Filter 1
19 551437104 Pull/Push Handle 1
20 551436107 Hose 1
21 551436108 Extension Wand 2
22 551436109 Floor Brush/ Squeegee Nozzle 1
23 551436110 Utility Nozzle 1
24 551436111 Crevice Tool 1
25 551002118 Foam Wet Filter 1
26 551188114 Dust Bag 1