Hasbro Martian Matter Alien Lab User manual

C
yan
Magenta
Yellow
B
lack
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
C
yan
Magenta
Yellow
B
lack
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
355
© 2008 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
NOT A FOOD ITEM. NONTOXIC.
NOTICE TO PARENTS: CONTAINS WHEAT.
NONTOXIC. CONFORMS TO ASTM D-4236.
Questions? Call: 1-800-327-8264
P/N 6850470003
Stain Advisement: Note that LUNAR LAVA™ gel may stain some surfaces.
Adult supervision is recommended. Wash with soap and warm water.
NOTE: Adult should remove and discard plastic packaging.
Molded results vary depending on child’s age and level of skill.
Product and colors may vary.
Cleaning up METEOR MUD™ compound: If spilt, remove excess
compound, allow to dry, then scrape or vacuum deposits away. Always
put compound back in container after play. Store in a cool place. If
necessary, water may be added one drop at a time to restore softness.
Visit www.martianmatter.com
AGES 5+
23976/23975 Asst.
CONTENTS: Playset with drip dish and drip dish plate, plastic knife, alien mold
plate, tweezers, 2 two-ounce bottles of LUNAR LAVA™ gel (net wt. 4 . oz., 118 ml)
and 1 three-ounce can of METEOR MUD™ compound (net wt. 3 oz., 85 g).
COMPOUND NET WT. 3 OZ. (85 g)
GEL NET WT. 4 FLUID OZ. (118 ml)
Class 1 LED product.
x3
BATTERIES REQUIRED
1.5V AAA or R03 size
Alkaline batteries recommended. Phillips/cross
head screwdriver (not included) needed to
insert batteries.
NOT INCLUDED
Important Cleaning Instructions:
LUNAR LAVA™ is reusable. Remove drip dish plate and pour
excess LUNAR LAVA™ gel into bottle.
1
Wash drip dish and drip dish plate with soap and
warm water. Wipe dry.
2
Wipe spilt LUNAR LAVA™ gel from light-up zone with a
damp cloth.
3
Alien mold plate
Drip dish
and drip
dish plate
Tweezers
Plastic knife
LUNAR LAVATM gel
Hatch
METEOR MUDTM
Compound LUNAR LAVATM gel
Dissection
table
Not suitable for children under 3 years because of
small parts – choking hazard.

B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
IMPORTANT: BATTERY INFORMATION
1. As with all small batteries, the batteries used with this toy should be kept
away from small children who still put things in their mouths. If they are
swallowed, promptly see a doctor and have the doctor phone
[phone] collect. If you reside outside the United States, have the
doctor call your local poison control center.
2. Always follow the instructions carefully. Use only batteries specified and be
sure to insert them correctly by matching the + and – polarity markings.
3. Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries.
4. Remove exhausted or dead batteries from the product.
5. Remove batteries if product is not to be played with for a long time.
6. Do not short-circuit the supply terminals.
7. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if necessary.
8. RECHARGEABLE BATTERIES: Do not mix these with any other types of
batteries. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
CAUTION:
T0 Insert batteries:
Battery cover is located on the
bottom of the Alien Lab™ playset.
Using a Phillips/cross head
screwdriver (not included),
loosen screw in battery
compartment cover (screw
stays attached to cover). Insert
3 x 1.5V “AAA” or R03 size
batteries (not included).
Replace cover and tighten screw.
4Let sit for 5 minutes.
Peel o alien skin with
the plastic knife and
tweezers provided.
5
Place removed skin over
guts, then press button
to light up the dissection
table.
6
Dissect the guts!
7
NOTE: Lights will turn
o automatically
after a short time.

B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
Make Alien Guts
1Press METEOR MUD™ compound into alien half-mold. Assembly
Insert drip dish into indentation and place
drip dish plate on top as shown.
Make Alien Skin
2Remove molded alien from half-mold
and trim excess compound with the
plastic knife provided.
3Place alien on drip dish plate and
squeeze LUNAR LAVA™ gel onto alien.
1Open hatch and ll chamber with METEOR MUD™
compound all the way to the rim.

B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
B
lack 355
File: 25984HB_239760000_239750000_MMT_alien lab.indd Date:13/Aug/08 150H-L
Place METEOR MUD™
compound disc on top of lled
guts impressions, and gently
pat it down.
6Let guts sit for 3-5 minutes to give LUNAR
LAVA™ gel time to harden.
2Push hatch down until it closes.
7After giving LUNAR LAVA™ gel time to harden, remove METEOR
MUD™ disc, and lift guts out of the METEOR MUD™ impression.
Use the plastic knife to cut away any excess LUNAR LAVA™ gel
from the guts.
3Open hatch. The METEOR
MUD™ compound now has
impressions of heart, spine
and brain guts in it.
Fill impressions with Lunar
Lava™ gel all the way to
the top, but do not overll
them.
4Place some METEOR MUD™ compound on a
smooth surface and atten it into a disc.
• TIP: For gooey guts,
remove from METEOR
MUD™ compound after
3 minutes. To create
solid guts, leave them
in the METEOR MUD™
compound for the full 5
minutes.
• NOTE: METEOR MUD™
compound is reusable! To
make more guts, repeat
steps 1–8.
8Place guts on dissection table.
5