Hathaway NG2351 User manual

3-IN-1 POKER TABLE
ASSEMBLY INSTRUCTIONS
NG2351/NG2366

THANK YOU!
Thank you for purchasing this product.
We work around the clock and around the globe to ensure that our products
maintain the highest possible quality. However, in the rare instance that your
product is defective or missing parts, contact your retailer, or call 800-759-0977,
to submit parts requests or warranty claims. Please read the warranty
information at the back of these assembly instructions for further details.
IMPORTANT! PLEASE READ THESE ASSEMBLY INSTRUCTIONS
IN ENTIRETY BEFORE ASSEMBLING YOUR PRODUCT.
2

PARTS IDENTIFIER (NOT TO SCALE)
TABLE
3

PARTS IDENTIFIER (NOT TO SCALE)
CHAIRS
4
Please see Parts List at end of manual for part number when ordering parts. For replacement parts please call 800-759-0977.

ASSEMBLY TIPS
1. Find a clean, level surface to begin the assembly of your game table. The table will be par-
tially assembled upside down and then turned over onto its legs. This is a heavy game and
turning it over will require at least two strong adults.
2. Remove all of the contents from box and verify that you have all of the parts shown on the
Note: Some parts may be pre-installed or pre-
assembled.
-
stand the text before beginning each assembly step.
5. Electric screwdrivers may be helpful during assembly; however, please set a low torque
and use extreme caution because screws may be stripped or overtightened if the electric
screwdriver's torque is set too high.
WARNINGS!
READ AND FOLLOW ALL ASSEMBLY, OPERATION AND SAFETY INSTRUCTIONS CAREFULLY.
CHOKE HAZARD - THIS TABLE CONTAINS SMALL PARTS - NOT SUITABLE FOR CHILDREN UNDER
3 YEARS OF AGE.
5
4. When installing parts that have more than one screw or bolt, hand tighten all screws or
bolts in place before finishing tightening with screwdriver or hex wrench.

ASSEMBLY INSTRUCTIONS
1. Attach PLATE #4 to PEDESTAL #3 with NUT #10 and FLAT WASHER #8.
2. Attach assembled PEDESTAL to the bottom of the TABLE BODY #1 with BOLT #7 and FLAT
WASHER #8.
3. Attach LEGS #2 to PEDESTAL with NUT #10 and FLAT WASHER #8. Thread one LEG LEVELER
#11 onto each LEG.
4. Carefully turn table over. Place TABLE TOP #5 on top of assembled TABLE.
6
TABLE

ASSEMBLY INSTRUCTIONS
1. Attach SEAT LIFT #18, BASE CAP #19 and LIFT COVER #20 to BASE #17.
2. Attach SEAT ADJUSTER #21 to the bottom of SEAT #16 with BOLT #22, LOCK WASHER #23
and FLAT WASHER #24. Note: The tilt tension dial should face towards the front of the chair.
3. Attach assembled SEAT to assembled BASE - top of SEAT LIFT ts into corresponding hole
in SEAT ADJUSTER.
7
CHAIRS

CONGRATULATIONS!
You have now assembled your Game Table. Please
note the Care and Use instructions below to ensure
years of trouble free use of your game table.
CARE AND USE
1. This product is intended for INDOOR use only.
2. Do NOT sit or climb on the table.
3. Do NOT drag the table when moving it as this will damage the legs.
8

1-YEAR LIMITED WARRANTY
This product is warranted to the original purchaser to be free from defects in material or workmanship
for a period of one year from the date of the original retail purchase.
This warranty does not cover defects or damage due to improper installation, alteration, accident or
any other event beyond the control of the manufacturer. Defects or damage resulting from misuse,
abuse or negligence will void this warranty. This warranty does not cover scratching or damage that
may result from normal usage.
This product is not intended for institutional or commercial use; the manufacturer does not assume
any liability for such use. Institutional or commercial use will void this warranty.
This warranty is nontransferable and is expressly limited to the repair or replacement of the defective
product. During the warranty period, the manufacturer shall repair or replace defective parts at no
cost tothe purchaser. Shipping charges and insurance are not covered and are the responsibility of
the purchaser. Labor charges and related expenses for removal, installation or replacement of the
product or components are not covered under this warranty.
The manufacturer reserves the right to make substitutions to warranty claims if parts are unavailable
or obsolete.
The manufacturer shall not be liable for loss of use of the product or other consequential or incidental
costs, expenses or damages incurred by the consumer of any other use. The user assumes all risk of
injury resulting from the use of this product.
This warranty is expressly in lieu of all other warranties, expressed or implied, including warranties of
. Neither the manufac-
turer nor any of its representatives assumes any other liability in connection with this product.
All warranty claims must be made through the retailer where the product was originally
purchased. A purchase receipt or other proof of date of purchase will be required to process
all warranty claims. The model number and part numbers found within the assembly
instructions will be required when submitting any parts requests or warranty claims.
For further warranty information or inquiries, please call 800-759-0977

3-IN-1 DARK OAK POKER TABLE - NG2351T
Parts List
PARTS
HARDWARE PACK - NGP2331 includes parts 6, 7, 8, 9 & 10
5/13* Replacement bumpers available as NGP2322 for red, and NG2323 for white
5
1
4
3
2
*
NGP2300 NGP2301 NGP2302 NGP2303 NGP2304
NGP2331 NGP2331 NGP2331 NGP2331 NGP2331
NGP2319 NGP2321 NGP2320 NGP5077 NGP5073

3-IN-1 DARK OAK CHAIRS - NG2351C
Parts List
PARTS
HARDWARE PACK - NGP2345 includes parts 22, 23 & 24
5/13
NGP2344 NGP2329 NGP2324 NGP2324 NGP2324
NGP2327 NGP2345 NGP2345 NGP2345
* * *
* Parts 18, 19 and 20 sold as set

3-IN-1 WALNUT POKER TABLE - NG2366T
Parts List
PARTS
HARDWARE PACK - NGP2331 includes parts 6, 7, 8, 9 & 10
5/13* Replacement bumpers available as NGP2322 for red, and NG2323 for white
5
1
4
3
2
*
NGP2307 NGP2308 NGP2309 NGP2310 NGP2311
NGP2331 NGP2331 NGP2331 NGP2331 NGP2331
NGP2319 NGP2321 NGP2320 NGP5077 NGP5073

3-IN-1 WALNUT CHAIRS - NG2366C
Parts List
PARTS
HARDWARE PACK - NGP2345 includes parts 22, 23 & 24
5/13
NGP2346 NGP2342 NGP2324 NGP2324 NGP2324
NGP2327 NGP2345 NGP2345 NGP2345
* * *
* Parts 18, 19 and 20 sold as set