HDS Systems EDC Executive Flashlight User manual

EDC Executive™ Flashlight User’s Guide
Copyright 2018 by HDS Systems, Inc.
All rights reserved.
Basic Operation
Clicking the button (a quick press and release of the button)
will turn on your flashlight to the Medium setting. Clicking the
button a second time will turn off your flashlight.
While your flashlight is on, you can press-and-hold the button
to momentarily activate the Maximum setting – releasing the
button returns to the previous brightness setting.You can also
click-press-hold-release to activate Maximum and stay on
the Maximum setting. There is no delay between the click and
the press.
You can select the Maximum setting directly from off by
performing a click-press-hold-release. There is no delay
between the click and the press.
While your flashlight is on, you can double-click to toggle
between the Medium and Medium High settings. A double-click
is two rapid clicks without a delay. A double-click will also return
you to whichever of the two settings you used last if you happen
to be on one of the other settings.
While your flashlight is on, you can triple-click to change to the
Low setting.A triple-click is three rapid clicks without a delay.
Low Battery Indication
Your flashlight will turn off momentarily and then back on one
level below the previous brightness level when the battery is
unable to supply enough power to run the current brightness
level. This process is repeated as needed as the battery’s
power is depleted.
Your flashlight will double-blink once every two minutes to
remind you that the battery needs to be changed when the
battery is no longer capable of maintaining a 50 lumen output
level and you are asking for an output level higher than the
battery can maintain.
Your flashlight restricts the output to the highest brightness level
the battery can maintain. However, if you turn off your flashlight
and turn it back on again to a higher level, your flashlight will
slowly step up through the brightness levels testing the battery
again.
Button Lockout
You can disable the switch by unscrewing the battery
compartment from the head one half turn. The O-ring will
remain completely covered. You restore operation of the switch
by screwing the battery compartment completely into the head.
You can also enable the Button Lockout option. When enabled,
triple-click from off locks and unlocks the button.
Cleaning and Maintenance
Periodically clean the open end of the battery compartment,
threads and O-ring with a clean lint-free cloth lightly moistened
with isopropyl alcohol. Apply a coat of non-conductive silicon or
petroleum grease to these surfaces.
Replace the battery compartment O-ring if it becomes worn or
damaged. O-ring: 1.5mm x 20.5mm, 70 durometer Nitrile
(Buna-N).
The recessed electrical contacts and interior threads in the head
can be cleaned using a lint-free swab lightly moistened with
isopropyl alcohol. Recessed contacts and threads should be
cleaned in a counter-clockwise direction to prevent snagging the
swab in the threads. Be sure to remove any particles or fibers

that may be left behind. Apply a coat of non-conductive silicon
or petroleum grease to the interior threads and contacts.
The exterior can be cleaned with a mild soap and water. Rinse
well and dry with a soft cotton cloth.
Note:the anti-reflective coating on the lens can be abraded by
excessive rubbing or cleaning. Never use paper tissues or
paper towels to clean or dry the lens as the fibers are abrasive.
Additional Information
Your flashlight has many capabilities not presented here.
Please see the EDC Clicky Advanced User's Guide on our web
site for a complete coverage of all features.
Warranty
Please view the full warranty on our web site.
Specifications subject to change without notice.
HDS Systems, Inc. Phone: [phone]
P.O. Box 42767 E-mail: [e-mail]
Tucson, Arizona 85733 USA Web: www.HDSsystems.com
Updated March 14, 2018. Software version 2.18.