healthtec 5001 User manual

User Manual
Adjustable and Fixed Height Plinth
MODEL: 5001, 5004, 6340 and 6341
SERIAL: __________________
NEED HELP?
FREECALL
1300 362 923

Page 2. © Healthtec Pty Ltd. 2019 www.healthtec.com.au
TABLE OF CONTENTS
TABLE OF CONTENTS ............................................................................................. 2
FORWARD ................................................................................................................ 3
ITEMS DESCRIPTION .............................................................................................. 3
DISCLAIMER ............................................................................................................. 3
SPECIFICATIONS ..................................................................................................... 3
INSTALLATION ......................................................................................................... 5
OPERATING INSTRUCTIONS ................................................................................. 6
VINYL CARE ............................................................................................................. 7
TROUBLE SHOOTING GUIDE ................................................................................. 8
THE HEALTHTEC WARRANTY ............................................................................... 9
THE HEALTHTEC WARRANTY CONT.....................................................................10

Page 3. © Healthtec Pty Ltd. 2019 www.healthtec.com.au
FORWARD
This manual has been prepared by Healthtec Pty Ltd for the owners of our
Healthtec™ range of Tables and/or Chairs.
It contains general information on how to operate, maintain and care for your
Healthtec™ equipment as well as a list of the relevant parts information and
operational diagrams.
Reading and understanding this manual thoroughly will not only maximize the life
and efficiency of your Healthtec™ Table and/or Chair, it will also aid in its safe
operation.
ITEMS DESCRIPTION
Healthtec™ Plinths
(Model # 5001,5004, 6340 & 6341)
(See specifications for particular details)
DISCLAIMER
The specifications put forth in this manual were in effect at the time of publication,
however due to Healthtec’s policy of continuous improvement, changes to these
specifications may be made at any time without any obligation on the part of
Healthtec™.
WARNING
Possible explosion hazard if used in the presence of flammable anaesthetics.
SPECIFICATIONS
On the following pages you will find the specifications for the equipment
mentioned in items description.
Specfications Shown:
•Upholstery Dimensions
•Minimum and Maximum Heights
•Movement in Degrees
•Safe Working Load (SWL) is 400kg

Page 4. © Healthtec Pty Ltd. 2019 www.healthtec.com.au

Page 5. © Healthtec Pty Ltd. 2013 www.healthtec.com.au
UNBOXING AND INSTALLATION
The table will arrive packaged in two box sections held in place with packing strips.
To unbox follow the following steps.
1. Cut the two plastic strips where shown.
2. Lift the box cover to reveal the table.
3. Lift the table out of the box base and place in a clear space on a level surface.
You may then discard of the packaging.
Notes on unboxing
• Be careful not to cut into the box as damage to the upholstery may occur
• Lift the product from the metal base of the table assembly rather than the table top.
There is no further assembly required on Healthtec™ tables. The electric actuators are
factory adjusted and do not require any further adjustment.
Plug the power plug into a normal 240v power outlet and test the motor to full height.

Page 6. © Healthtec Pty Ltd. 2019 www.healthtec.com.au
OPERATING INSTRUCTIONS
Elevating the Head and End Section:
Raise the
Head Section or End Section to the
position required.
To Lower the Head
or End Section you first have
to lift the
Head or End Section to the maximum
height and then it will drop down.
Adjusting the Height of your Plinth.
To Adjust the Height of your plinth,
1.Undo the Tri-Wheel
2.Press Adjustment Button all the way in.
3. Pull Plinth Leg out to desired height.
Make sure that Adjustment Button clicks in to a
hole and that Plinth Leg is secure.
4. Tighten Tri-Wheel.
REPETE PROCESS FOR ALL FOUR PLINTH
LEGS
ADJUSTMENT
BUTTON
TRI-WHEEL
PLINTH LEG

Page 7. © Healthtec Pty Ltd. 2019 www.healthtec.com.au
VINYL CARE
The vinyl upholstery requires cleaning with warm soapy water to remove skin oil
from surfaces, especially around the areas where the face, back or chest come
into contact with vinyl.
Cleaning intervals should be once per day depending on use.
Note: Do not use alcohol or aromatic solvents to clean upholstery.
Treatment of Specific Stains
Always remember:
•Prompt attention yields more complete removal
•Wipe stains from ‘outside in’ to avoid spreading.
Lipstick, Shoe Polishes, Fatty & Greasy Stains
Remove as much of the stain as possible with edge of spoon, then wipe with cloth
moistened with methylated spirits. Wash with warm soapy water and dry with
clean cloth.
Chewing Gum
Set the gum hard with an ice cube. Then scrape over with the edge of a spoon.
Wipe over with methylated spirits and finally with warm soapy water.
Ball Point Pen Ink
Wiping with methylated spirits is sometimes effective if stain is fresh. If stain is dry,
treat with paste made from Fullers Earth or Light Kaolin (available from local
chemist) and a bleach mixed with a few drops of methylated spirits. Apply to stain
and allow to dry for three hours. More than one application may be needed if the
stain has been present for some time.
Important
Never use furniture polishes, abrasive cleaners, steel wool or cleaners containing
solvents as these items can cause damage to the vinyl surface.

TROUBLE SHOOTING GUIDE
_______________________________
PROBLEM:
Head Pad or End Pad moves when weight is applied.
POSSIBLE SOLUTIONS:
Broken rachet adjuster, replace orcall for
service._______________________________

Page 9. © Healthtec Pty Ltd. 2019 www.healthtec.com.au
THE HEALTHTEC WARRANTY
1. Healthtec Pty Ltd (Healthtec) warrants that the product is free of defects in material and
manufacture when it leaves the factory and will address any defects in material or
workmanship without charge as defined below.
2. The warranty is valid for five (5) years for electrical functions of motors and foot
switches from the date of purchase. This warranty is transferrable to any subsequent
owner of the product during the warranty period.
3. The warranty is valid for the lifetime of the product for workmanship of structural
manufacture. This warranty is transerrable to any subsequent owner of the product.
4. The warranty is limited to the repair and/or replacement of defective parts and/or
assemblies. The decision to repair and/or replace will be soley at the discretion of
Healthtec. Repair works will be undertaken at Healthtec’s service facility or that of a
Healthtec-approved agent on receipt of the product freighted from the customer.
5. This warranty is valid only for products displaying the Healthec serial number on its
label. Please register your product with Healthtec to help expedite any warranty claims.
6. Healthtec does not authorize any person or representative to create for it any other
obligation or liability in connection with the sale of its products. Any representative or
agreement not contained in this warranty shall be void and of no effect.
This warranty does not cover
7. The cost of freight to or from a Healthtec service facility or Healthtec-authorized agent.
8. The cost of labour and transport of Healthtec technicians or Healthtec-authorised
agents to or from a warranty repair away from a Healthtec service facility.
9. Any replacement parts or labor furnished by anyone other than Healthtec or a
Healthtec-authorised agent.
10. Any malfunction or failure in the product that is not caused by a defect in the material or
workmanship or if the malfunction or failure is caused by unreasonable use, including
the failure to provide reasonable and necessary maintenance.
11. Any original suppliers warranty of components and materials (ie. vinyl upholstery
covering).
12. The warranty does not extend to or bind or obligate Healthec to pay any consequential
damange or expediture to business or property caused as a result of any defect in the
product.
WARRANTY REGISTRATION
To register your warranty the company, visit our website at
http://www.healthtec.com.au/warranty-registration

WARRANTY CLAIM PROCESS
To obtain service from Healthtec or an authorised agent under this warranty the owner must
abide by the following process:
STEP 1— REPORT
A written report of the problem encountered must be made by the customer within seven (7)
days of first becoming aware of the problem; and sent to:
HEALTHTEC PTY LTD
132 Tennyson Memorial Ave, Tennyson, QLD, 4104
or; emailed to [e-mail]
or; register a service request online at http://www.healthtec.com.au/service-request
On receipt of a warranty claim, a Healthtec representitive will contact you to discuss the
problem and make arrangements for the product to be returned if applicable.
STEP 2 — RETURN
The product must be returned to Healthtec for assessment and claim resolution and be
transported securely so that no additional damage can occur. The cost of transportation is
the responsibility of the customer.
STEP 3 — RESOLUTION
Healthtec service technicians will assess the reported problem and determine if a repair
and/or replacement is warranted and undertake the applicable course of action. The
resolution of the warranty claim should occur within a period of thirty (30) days from receipt
of the returned product.
Upon resolution of the warranty claim, the customer can arrange safe return transportation
of the product to them. The cost of transportation is the responsibility of the customer.
Page 10 © Healthtec Pty Ltd. 2019 www.healthtec.com.au