hi-Fun hi-Edo User manual
UserManual
BluetoothHeadset
ModelName:hi‐Edo
FCCID:R2MHI‐EDO
ENG
1
57
8
3
6
4
2
Legend
ENG
1) Switch on hi-Edo.
To switch on hi-Edo hold the button (1) until warning LED (2) turns on. Afterwards hi-Edo automatically connects itself to
....the.2) flash slowly in blue to confirm the connection. If there is no
....available paired device or if it is out of range of hi-E
....discharging.
2) Pair hi-Edo with a compatible device.
To pair hi-E2) which flashes
Edo and switch it on
holding the starting button (1) until the warning LED (2) will flash alternately red and blue.
Main functions
ENG
3) Switch off hi-Edo.
....To switch off hi-Edo hold the central button (1) for 4 seconds untill the warning LED (2) flashes in red.
Now you can select hi-E
(2) flashes slowly in blue.
E7)).
Thanks to the buttons on the right side of hi-E
Moreover is possible to adjust the volume.
Playing music
ENG
1)
2)
3)
4)
5)
While you are listening to the music the warning LED (2) flashes in blue.
WARNINGE
ear damage.
To play press shortly the button (1).
To adjust the volume press the volume button “+” (3) to increase it or the volume button “–“ (4) to decrease it.
To switch to the next song in your playlist press the button “ ” (5). To switch to the previous song in your playlist press
the button “ ” (6)
To stop the music press shortly the button (1).
ENG
Answer a call.
To answer a call press briefly the button (1).
End a call.
To end a call press briefly the button (1) during the call.
Reject an incoming call.
To reject an incoming call hold the button (1
incoming call is rejected.
If hi-E
microphone (7) and to the buttons on the side.
Make and receive a call
1)
2)
3)
4)
ENG
Charge hi-Edo
1) for 2 seconds until you ear a tone from the hi-Edo; when
....you hear the second tone you can say the command.
5) Call the last selected number.
....Press twice (double click) the button (1).
music.
When hi-Edo battery is discharged warning LED (2) starts flashing red. It indicates that in few minutes hi-Edo is turning off
in order to preserve the battery. To charge the battery connect the hi-E
ENG
Technical specifications
Charge time: about 30 minutes
Weight: 150g
It is possible to charge hi-Edo while in use.
As soon as the charger cable is connected to the plug (82) turns on red and it turns off once the charging
is completed. When the hi-E
ENG
Warnings
- Avoid listening to the music at loud volume for a long time: risk of ear damage.
- Follow the local rules about mobile phones usage and their accessories while driving.
- Keep hi-Edo out of the reach of small children to avoid chocking hazard.
- Switch off hi-Edo before a flight. Do not use it on a plane if not permitted by the airline.
- Keep hi-Edo dry and avoid humidity.
- Disconnect hi-Edo from charging cable before polishing it.
- Do not use hi-Edo if it does get wet.
..hi-Edo: danger of explosion.
- At the end of battery lifecycle do not dispose it as household waste. Dispose of batteries according to local regulations.
..Please ..recycle when possible.
IMPORTANT REGULATORY INFORMATION
This device complies with Part 15 of the FCC Rules: Operation is subject to the
following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference that is received, including any
interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Other manuals for hi-Edo
1
Table of contents
Other hi-Fun Headset manuals
