Highfield PA420 User manual

Highfield Boats
Rear Tow Post Installation Guide
(PA420-460)
RTPIG2021V1

Installation Guide: Rear Tow Post
①Red stickers indicate the location of holes for installation. Tear off the stickers and
cut the anti-skid PVC decking to expose the holes. Do not remove the anti-skid fabric.
② Use insulating compound to eliminate corrosion between the aluminum and the
stainless steel screws.
Recommended corrosion inhibitor: Duralac, Tef-Gel, Lanocote
Page 1/3

Installation Guide: Rear Tow Post
③Gently clean the deck. Secure the rear tow post using polyurethane marine grade
adhesive such as 3M 5200, Sika 291, Fixtech Fix 15.
④ Use insulating compound on the M8 stainless steel screws supplied with the rollbar.
Fasten the rollbar to the deck and transom using the screws.
Page 2/3
polyurethane marine grade adhesive
1—Screw M8×40mm;
2—Stainless steel flat washer M8
3—Plastic washer M8
4—Rear tow post base;
5
—
Deck/Transom

Installation Guide: Rear Tow Post
Congratulations, you have successfully installed the rear tow post.
Page 3/3