HOLOCUREN Sled Guide User manual

CRAFTERS
HOT KNIFE
NEW ROD-STYLE
TOOL KIT
NEW Sled Guide/Table Adaptor/Rod
Stand for precision cutting and safety
“The must-have t l f r every
m del-maker’s t l kit.”
FEATURES:
• C ntinuus duty cycle tls (won't shut down
to cool)
• C nvenient stay- n pwer switch
• Heats t ver 750 F in 1 minute
• R d-shape blade easily cuts c rners & circles
• Free style cuts by hand
• New technl gy: Stainless Steel Outer Tube
with inner ceramic heating element f r
nn-st p, ht precisin cutting
• 110 vlts220 vlts
• Perfect f r cutting wire channels and electrical
bxes in f am insulatin
PROFESSIONAL & INDUSTRIAL USES:
F am Fabricat rs Ribb n & fabric Electricians
Architectural M dels Candle Making
M del Railr ads
Battlefield Terrain Village
M del Making T
heater Pr ps & Sets F am
Sculpting ICF Builders
“Perfect f r cutting ICF wire channels
and electrical b xes in f am.”
3-PIECE KIT • 6” ROD • POWER SUPPLY • SLED
3-PIECE KIT • 9” ROD • POWER SUPPLY • SLED
4-PIECE KIT • 6” & 9” ROD • POWER SUPPLY • SLED
CraftersHotKnife.co
PATENT
FOAM CUTTER • FABRIC CUTTER • WAX CUTTER

Warning
1. This device can be extre ely hot and ust be operated with great
care. Keep the rod away fro fla able objects and away fro
skin.
2. Do not sub erge the Rod into water. It could cause a short-circuit
and/or electric shock.
3. Never leave the Rod in reach of children.
Specificati ns
Power Supply: 9 feet cord
Input 110 VAC
Input 220 VAC
Stainless Steel Rod: 6" Rod
9" Rod
Operation Te perature: 800oF
Operating Instructi ns
Free Hand Operati n
1. Plug Power supply into power outlet and connect the Rod to the
9' cord.
2. Turn the ON/OFF switch to ON position.
3. Wait approxi ately one inute to heat the Rod.
4. Once the Rod is hot, it is ready to cut the aterial.
5. After cutting is co plete, turn the power switch to OFF position.
6. Disconnect Rod fro the power cord and power cord fro outlet.
Sled Guide Operati n
1. Asse ble the Sled guide.
2. Point the Rod downward and push into the U shaped Rod Holder
on the sled.
3. Adjust the angle and depth of the Rod and tighten screw to secure
the position.
4. Place the Sled Guide on top of the foa with Rod pointing down
next to the cutting line.
5. Slide the Sled and Rod along the top of the foa with proper
speed.
Table Adapt r Operati n
1. Asse ble the Sled Guide/Table Adaptor.
2. Tape or bolt the table Adaptor to the edge of a table or piece of
plywood with the U-shaped Rod Holder facing out.
3. Attach the 6" or 9" Rod to the Table Adaptor with the blade facing
upward.
4. Set angle and tighten the screw to secure the position.
5. Place foa on the table and push foa toward and through the
heated Rod at the cutting line with proper speed.
Marketed by
TL Marshall C mpany
Burbank CA 91506
Produced by
Tais Industry Inc
Riverside CA 92503