Holtz 303LRK2 User manual

Lock Release Auto Can Lid Lock
Flat or Slope Dumpsters-Side Mount
Part No: 303LRK2
FIG 1
Parts List
#1 2 Carriage Bolts
#2 2 Flange nuts (self-locking)
#3 1 Lock release with
pivot plate
#4 2 Side plates welded to
number 5
#5* 1 Sch. 40 x 3/4” LD Pipe
#6 1 Pivot Plate
*NOTE: #5 IS NOT INCLUDED
Must purchase bar seperately
1
3
2
4
5* Not Included
Must purchase
seperately
6
Padlock
Hole
Before you begin, please read through the entire instructions.
To assemble and install the kit, you will ned channel locks, two “C”
clamps, and adjustable wrench and a drill with 3/8” drill bit. You will
also need ve of each of the following: 3/8” carraige bolts, nuts,
at washers and (optional) lock washers.
NOTE: IMPROPERLY FITTING LIDS
Lids that hang over or have handles that hang over the front of the container may cause complications
during mounting and/or operation of the automatic lock.
Step 1: Assemble kit as shown in FIG 1. Making sure that the
padlock hole is toward the front of the container. Use
channel locks to tighten ange nuts.
Step 2: Position lock release on le side of container, ush
with the top of the channel and even with the front of the
lids as shown in FIG 2. Clamp in place.
Step 3: Position pivot plate on right side of container, ush
with the top of the channel and even with the front of the
lids as shown in FIG 3. Clamp in place.
Step 4: Drill holes and bolt on with carraige bolts.
Holtz Industries, Inc.
Call Us Toll Free: 1-800-535-0104
FIG 2
FIG 3
Le Side
Right Side
Front of
lids and kit
are even.
Front of
lids and kit
are even.
Front of
container.
Front of
container.

Driver Instructions
e driver’s job is simple. Just stay in the truck and li the can as if the lock
were not there. e lock opens and closes automatically during the normal
dump cycle.
Customer Instructions
e Serio-us Lock is designed to accomodate any standard padlock. e cus-
tomer supplies her or her own padlock to keep the container locked while it
is on the ground. To open the container, the customer removes the padlock/
lock release cable, lowers the lock bar and opens the lid. To close the con-
tainer, the steps are reversed.
Holtz Industries, Inc.
Call Us Toll Free: 1-800-535-0104