Assembling the tree
Pleaseremove protective covers fromthe base of thepole for each tree
section before assembling.
Step 1. Insert tree bottom (D) into the tree stand and tighten the screw.
(See Fig. 1)
Step2.Insertlowermiddlesection (C)intothetreebottom(D).(See Fig. 2)
Step 3. Insert upper middle section (B) into the lower middle section (C).
(See Fig. 3)
Step 4. Insert tree top (A) into the upper middle section (B). (See Fig. 4)
Step 5. Allow branches to fall into place or gently pull branches up and out.
When adjusting branches be sure that all wires are free of branch
hinges. (See Fig. 5)
Step 6. Shape the branches. Starting with tips closest to the pole, shape
one tip to the right, one to the left and oneat the center of the main
stem. Repeat pattern for each branch. (See Fig. 6)
Step 7. Plug the power cord into a proper outlet. Please note this tree is
locked in the Demo function. The tree cycles automatically
through 2-9 functions below.
Thefoot pedal switch only has switch function. The remote control
only works ON/OFF. Please unlock the Demo function first, then
thefoot pedal switch and the remote control can work normally.
This tree is Color Changing, the 9 lighting options available are:
1. Demo
2. Steady Warm White
3. Flashing Warm White
4. Fade In and Fade Out Warm White
5. Steady Multicolor
6. Flashing Multicolor
7. Fade In and Fade Out Multicolor
8. Sequential Multicolor & Warm White
9. Color Changing
These functions can be changed by pressing the foot pedal
switch or using the remote control after unlocking the Demo
function. Please see the Operation below to see how to unlock
and lock the Demo function.
Operation
Turning on the tree
Step 1. Connect each tree section well and plug the power cord into a wall
outlet.
Step 2. Unlock the Demo function. Press the remote control or foot pedal
switch to choose functions.
How to Unlock the Demo function:
1. Press the foot pedal switch for more than 5 seconds, the product will
flash 1 time, then the foot pedal switch and remote control are
unlocked in the Demo function.
2. Press the Demo button on the remote control for more than 3 seconds,
theproductwillfalshing for1time,then the footpedal switchandremote
control are unlocked in the Demo function.
How to Lock the Demo function:
1. Press the foot pedal switch for more than 5 seconds, the product will
flash 3 times, then the footpedal switch and remote control arelocked
in the Demo function.
2. Press the Demo button on the remote control for more than 3 seconds,
the product will flashing for 3 times, then the foot pedal switch and
remote control arelocked in the Demo function.
Instruction of remote control
Please note this tree has a remote control.
Please pull out the insulation tape from the remote control, before starting
to use it.
1. Unlock the Demo function:
2. Press Fn button, select the function below in proper order. Press the
function key, select from the following corresponding lighting
functions:
Function 1: Demo
Function 2: Steady Warm White
Function3: Flashing Warm White
Function4: Fade In and Fade Out Warm White
Function 5: Steady Multicolor
Function6: Flashing Multicolor
Function7: Fade In and Fade Out Multicolor
Function8: Sequential Multicolor & Warm White
Function 9: Color Changing
There is memory modeon function adjustment.
If the remote control does not work, check whether the battery of the
remote control is out of power.
To replace the remote control battery:
1. Replacewithanewbuttoncell“CR2025”(3volt)into
the compartment.
CAUTION: DO NOT DISPOSE OF
BATTERIES IN FIRE. BATTERIES MAY EXPLODE
OR LEAK.
Use and Care Instructions
a) Before using or reusing, inspect product carefully. Discard any
products that have cut , damaged, or frayed wire insulation or cords,
cracks in the lampholders or enclosures, loose connections, or
exposed copper wire.
b) When storing the product, carefully remove the product from wherever
it is placed, including tree, branches, or bushes, to avoid any undue
strain or stress on the product conductors, connections, and wires.
c) When not in use, store neatly in a cool, dry location protected from
sunlight.
