Home Decorators Collection 100 Series User manual

Page 1
3 Light Pendant in Brushed Nickel Finish
Home Depot SKU 100xxxxxxx (UPC 718212174258)
(Brushed Nickel Fixture)
Home Depot SKU 100xxxxxxx (UPC 000000000000)
INSTRUCTION MANUAL

Page 2
FEATURES:
1. Traditional 3 Light Pendant in Brushed Nickel Finish.
2. Timeless Elegant Design.
3. Easy to assemble and install.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer
Service Team at 1-855-HD-Hampton or visit www.homedeot.com.
reference your SKU (100xxxxxxx Brushed Nickel fixture) or UPC
(000000000000 Brushed Nickel fixture).
1-800-9 86 -346 0 or visit www.homedepot.com. Please
Thank you for purchasing this Home Decorators Collection interior light
fixture. This product has been manufactured with the highest standards of
safety and quality.

Page 3
CAUTION:
1. Before starting installation of this fixture or removal of a previous
fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY
ELECTRICAL QUESTIONS.
3. If you have any non-electrical questions about this fixture, please
855-HD-Hampton or
visit www.homedepot.com. Please reference your SKU (100xxxxxxx
Brushed Nickel fixture) or UPC (718212174258 Brushed Nickel fixture).
4. Keep your receipt and these Instructions for Proof of Purchase.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Light Bulb
(100 watt maximum) Safety goggles Step Ladder Wire strippers
Flathead screwdrive
r
Phillips screwdriver Electrical tape Wire cutters
www.homedepot.com. Please reference your SKU (100xxxxxxx
Brushed Nickel fixture) or UPC (000000000000 Brushed Nickel fixture).
contact our Customer Service Team at 1-800-986-3460 or visit

Page 4
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
ASSEMBLY INSTRUCTIONS:
1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture
and all mounting hardware from outlet box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care
not to lose any small parts necessary for installation.
4. Screw the Loop (#1) to top of the distributor.
5. Thread Nipple (#2) to the bottom of Fixtures Body (#7).
6. Slide Glass Shade (#5) upwards over Nipple (#2). While holding the Glass Shade, slide
(#6).
Metal Washer (#3) and Rubber Washer (#4) over the Nipple (#2),and secure with Finial
1
Loop
(#1) 1
Nipple
(#2) 1
Glass Shade
(#5) 1
Finial
(#6)
1
Rubber Washer
(#4) 1
Metal Washer
(#3)
3. Adjust the Arms (#20 ) to the proper position.

Page 5
ASSEMBLY:

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
INSTALLATION INSTRUCTIONS:
Place Hex Nut (#12) over end of Nipple (#15) and thread Nipple (#15) into Ceiling Loop
1
Crossbar
(#17) 2
Hex Nut
(#13) 1
Nipple
(#12) 1
Ground Screw
(#16)
1
Ceiling Loop with Chain
(#11) 1
Quick Link
(#8)
1
Lock Collar
(#9)
2
Lock Washer
(#14) 3
Wire Connector
(#18) 1
Canopy
(#10)
2
Outlet Box Screws
1. Thread Nipple (#12) into Ceiling Loop (#11) until snug.
2. Thread other end of Nipple with Loop attached into crossbar (#17) until snug.
3. Place Lock Washer (#14) over end of Nipple protruding through crossbar and thread
Hex Nut (#13) onto nipple until tight.
4. Take the crossbar assembly and mount to ceiling outlet box (#19) with outlet box
screws (#15). Tighten screws securely with screwdriver.
5. By measuring determine correct number of links needed for proper hanging height.
Use a pair of pliers to open one end link of the chain and discard un- wanted chain.
(Don’t disregard the Quick Link linked at the end of Chain.)
6. Slip Canopy (#10) and LockCollar (#9) through over the Ceiling Loop with Chain
(#11), then connect the other end of Ceiling Loop with Chain (#11) to Fixture Loop (#1)
by using Quick Link (#8).
7. Lace the fixture’s wires through the chain links and pull until taut. Feed the fixture
wires through the Lock Collar, Canopy, Ceiling Loop with chain and Nipple and pull
until taut.
8. Connect the ribbed wire from the fixture to the Neutral wire from the outlet box (#19)
and the smooth wire from the fixture to the hot wire from the outlet box (#19). Cover
the two wire connections using the two provided wire connectors (#18). Wrap the
two wire connections with electrical tape for a more secure connection. If your outlet
box has a ground wire (green or bare copper), connect fixture’s ground wire to it
using the wire connector (#18). Otherwise connect the copper ground from the
fixture to Ground screw (#16) on the Crossbar (#17) Note: If you have electrical
questions, consult your local electrical code for approved grounding methods.
9. Tuck these wire connections neatly into the ceiling outlet box and then raise the
canopy all the way to the ceiling. Raise the Lock Collar and thread onto Ceiling
Loop protruding through Canopy.
10. Install Light bulbs (not included) in accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)
11. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.

Page 7
INSTALLATION:
1.
Loop
8.
Quick Link
9.
Lock Collar
10.
Canopy
11.
Ceiling Loop with Chain
12.
Nipple
13.
Hex Nut
14.
Lock Washer
15.
Outlet Box Screws
16.
Ground Screw
18.
Wire Connector
17.
Crossbar
19
.Outlet Box
Ground Wire
Neutral Wire
(ibbed)
Hot Wire (Smooth)

Page 8
TROUBLESHOOTING:
PRODUCT MAINTENANCE:
1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the glass and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off
the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly
dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and
interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of five (5) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident,
modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found
to have been improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material
or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface
and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specially disclaims any warranty, whether express or implied,
of fitness for a particular purpose, other than the warranty contained herein. The manufacturer
specifically disclaims any liability and shall not be liable for any consequential or incidental loss or
damage, including but not limited to any labor / expense costs involved in the replacement or repair of
said product.
Possible Cause Corrective Action
1. Bulb is burned out. 1. Replace light bulb.
2. Power is off. 2. Make sure power
supply is on.
3. Faulty wire connection. 3. Check wiring.
Bulb will not light.
4. Faulty switch. 4. Test or replace switch.
Fuse blows or circuit
breaker trips when light
is turned on.
Crossed wires or power wire
is grounding out. Check wire connections.

Page 9
Lampara colg ante de3 Luces en níquel cepillado en Finalizar
SKU 100xxxxxxx de Home Depot (UPC 0000000000000)
(Lámpara en Níquel Cepillado)
MANUAL DE INSTRUCCIONES

Page 10
CARACTERÍSTICAS:
1. Tradicional Lampara colgante de3 Luces en níquel cepillado en Finalizar.
2. Diseño clásico y elegante.
3. Fácil de ensamblar e instalar.
PREGUNTAS, PROBLEMAS, PIEZAS FALTANTES:
Antes de regresar a su oficina local de Home Depot, llame a nuestro
Servicio de Atención al 1-800-986-3460 o visite www.homedepot.com.
Por favor, referir a SKU (100xxxxxxx Lámpara en Níquel cepillado), UPC
(000000000000 Lámpara en Níquel cepillado).
Gracias por la compra de este accesorio Home Decorators Collection luz
interior. Este producto ha sido fabricado con los más altos niveles de
seguridad y calidad.