Home Zone Security ES00756V User manual

LED Wall Pack Light
Model No. ES00756V
[phone]
IMPORTANT SAFETY OPERATING INSTRUCTIONS
1. Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage
caused by fire, cuts, bruises, death and other dangers.
2. Please follow these general precautions before installing, maintaining, or fixing
1. Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
2. Make sure all electrical and grounded connections are in accordance with the National Electrical Code and
applicable local code requirements.
3. All wiring connections should be in compliance with UL standard.
1. Illumination output: approx. 1300 lumens / 3000K
2. Wattage: 13W
3. Power source: AC120V/60Hz
4. Dusk to dawn
REF. PARTS
PARAMETER:
securit y
www.homezonesecurity.com
RISK OF ELECTRICAL SHOCK
1. Wear gloves and safety glasses at all times when moving luminaire from carton, installing, servicing or
performing maintenance.
2. Avoid direct eye exposure to the light source while it is on. Or this may cause irreparable damage to the
eyes.
3. Account for small parts and destroy packing material, as these may be hazardous to children.
RISK OF INJURY
1. Allow fixture to cool before before touch.
2. Do not exceed maximum wattage marked on luminaire label.
RISK OF BURN
Attention: lights must to be installed by the experienced household wire installer or a qualified electrician,
Electrical system and the electrical connection method of light fixture must conform to the national electrical
standards and specification requirements of the local architecture.
A B C D E F G H
A 1PC D Mounting screw #1 2PCS G Centre screw 1PC
B 1PC E Mounting screw #2 2PCS H Rubber cap 1PC
C 2PCS F GND screw 1PC
Light fixture
Mounting bracket
Wire nut

Line up the holes on the mounting bracket (B) with the holes on your
junction box. Using the two suitable mounting screws (D or E) attach
the mounting bracket (B) to your junction box and fix it tightly.
[phone]
HOW TO INSTALL
LED Wall Pack Light
Model No. ES00756V
securit y
www.homezonesecurity.com
Figure 1: Install mounting bracket
Connect the light fixture wires to the junction box wires with wire nut (C)
* Black to L wire
* White to N wire
* Ground wire to GND with GND screw
Figure 2: Connect power wire
Install the light fixture (A) to the mounting bracket (B) with center screw
(G), then cover the rubber cap (H) in the screw hole.
NOTE: Before attaching the fixture to the junction box, make sure all the
lines are in the junction box or in the fixture body.
Figure 3: Install the light fixture
Figure 1
Figure 2
Figure 3