INSTALLATION INSTRUCTIONS
NOTE: Before assembly, ensure that all parts
and quantities match parts list below. Inspect all
components for shipping damage. If any parts are
determined to be missing or damaged, contact
your dealer/retailer for replacements. WARNING!
DO NOT use this equipment without first reading
and understanding the user manual. If you are
unable to understand these instructions, contact a
healthcare professional, dealer, or technical person
before installing. Otherwise, injury or damage may
occur. Symbols Glossary located at http://www.
performancehealth.com/medical-device-glossary.
PARTS LIST
A. Seat – 1 each
B. Leg – 4 each
C. Arms – 2 each
D. Back – 1 each
ASSEMBLY INSTRUCTIONS
1. Place seat upside down on a flat surface. Insert
each leg into the corner recess of the seat and
rotate counter-clockwise until tight. Repeat step
#1 for all 4 legs.
2. Place chair upright and insert arms into holes
in side of seat until arm is fully engaged.
3. Insert back into the slot, which is in the rear
of the seat, and insert back until fully engaged.
4. To adjust legs for proper height or uneven
surfaces, grab the shower chair leg with one
hand while rotating the bottom of the leg
(where the suction cup attaches to the leg)
clockwise. The leg has an adjustment window
that indicates the level with a red marker.
Turn to desired height and repeat for all legs.
CAUTIONS
• Ensure all 4 legs are at the correct height. The leg
has an adjustment window that indicates the level
with a red marker. Turn to desired height and repeat
for all four legs.
• Only use the Shower Chair for its intended use. They
are not replacements for ladders and are not
exercise equipment or toys.
• The Shower Chair is not intended for use during
examinations or treatments.
• Use only spare parts and accessories released by
Performance Health.
• Do not carry out structural changes which are not
approved by the manufacturer.
• The Shower Chair must not be used in environments
in which flammable gases or vapours (e.g. from
anaesthetics) can be expected.
CLEANING
• Small stains and dust are best removed with
moist wipes.
• Larger stains can be removed by non-scouring,
mild cleaning agents.
• Do not use tools with sharp edges (knives, metal
scrapers) or aggressive solvents for cleaning.
MAINTENANCE
The Shower Chair is maintenance-free, however,
should be checked monthly for damage or looseness.
Carry out the following test:
• Visual check of all parts for deformation, damage,
wear and tear and corrosion.
The chair must not be used further if faults/defects
are detected during use.
Homecraft Shower Chair
with Back and Arms
Maximum User Weight: 400lbs/180kg
Model 7103081
The following manual provides descriptions
relating to the installation of the Homecraft
Shower Chair with Back and Arms.
