HoMedics Tanda Luxe User manual

Important safety information
It is important to use Luxe as directed. For important information about safety and how to use
the device, read the full Instructions for Use booklet.
Note: DO NOT USE if you are sensitive to light or are taking medication that causes sensitivity to light.
DO NOT USE over any suspicious or cancerous lesions. DO NOT USE if you are pregnant. DO NOT stare
directly into the light.
Is Luxe right for you?
Luxe is used to treat wrinkles, rhytides, and ne lines in the periorbital area (around the eyes), often
called “crow’s feet.”
How to use
Your device has an internal rechargeable battery. You will need to fully charge your device for
approximately 4 hours before the rst use.
Step 1: Prepare skin for treatment
Before use, cleanse your skin to remove makeup or creams that may contain reective materials.
Step 2: Treat your skin
Press the orange power button once to activate the luxe device; lightly place the treatment head
over target areas (ex. around the eyes) for 3 minutes, twice weekly.
Step 3: After treatment
Apply your favourite skincare products, as your skin is now better prepared to absorb other products.
Quick reference guide

Luxe controls
The device is built with several user friendly features for a safe and easy experience.
Sensors
Contact sensor The rejuvenating red light, sonic vibration and gentle warming will only
activate when the treatment head is in direct contact with the skin.
Temperature sensor The device treatment head has a built-in temperature sensor that will turn
the device off if the treatment head surface gets too warm. Allow the
device to cool for 5-10 minutes before restarting.
Light indicators
Flashing green The device is ready or delivering a treatment
Steady orange The battery is being charged
Steady red An error has occurred. It may be:
• A problem with the installation of the treatment head
• The battery is low on power
• The unit may be overheating
Off The device is off
Sound indicators
One beep Start of treatment
One quick beep
every 30 seconds
A treatment is underway and it has been 30 seconds since
the last beep or the beginning of the treatment
Two beeps End of treatment cycle or low battery
Three beeps High temperature on treatment head surface
Four beeps Treatment head has been disconnected
Quick reference guide
IB-TandaLuxeQSEN-1011-01 10743 R00