HOMELEADER L34-004 User manual

INSTRUCTION MANUAL
Towel Warmer
Model: L34-004
Rated Voltage: 110V/60Hz Rated Input: 120W
For any questions, please contact us through Amazon message,
or write to [e-mail]

Confirm Parts
Check that all of parts are enclosed as the contents list
If there are any missing or damaged parts please contact us immediately
Parts List
Tools Required (not included)

Notice
Make sure to clean the product before use.
Wipe the surface with a soft damp cloth and do not use abrasive cleaners on the
product.
If you will not use it for a long time, please wipe the product with a dry cloth
before use.
Make sure to use the correct plug and power according to the user manual.
Hardwired & Plug-in
This towel warmer allowed to hard wired or plugged into a wall outlet.
Hardwired installation need to cut the power cable. This should be done by an
electrician.
Installation
1. Assemble the bracket for towel warmer
Using hexagon spanner ''G'' and screw ''B''
to install the towel warmer bracket ''A''.
2. Confirm the installation position of the towel warmer
Measure the distance between the four brackets with
a ruler and confirm the position on the wall.

3. Drill the hole on the right position, install the wall base
Drill the hole on the right position, insert the plastic wall anchors ''C''.
Then install the wall bases ''F'' on the wall with long screws ''D' 'and tighten.
Note: Please install the metal wall base to the wiring position if you want to
hardwired.
4. Plug-in towel warmer installation
Align the towel warmer bracket ‘’A’’ with the wall base ‘’F’’. Using hexagon spanner
''G'' and 5mm small screw ''E'' to fix the towel warmer on the wall.
Plug in the power supply and complete the installation.
4. Hardwired towel warmer installation
1. Cut the wires, make the wires come out from the towel warmer bracket.
2. Strip all three wires shell. Connect the three wires to the live, neutral and ground
wires, through the metal wall base.
3. Align the towel warmer bracket ‘’A’’ with the wall base ‘’F’’ . Using hexagon spanner
''G'' and 5mm small screw ''E'' to fix the towel warmer on the wall.