Honeywell Notifier DA-60 Technical manual

ECN09
-
053
1
1. Product Overview
The DA-60 Building OccupantWarning System (BOWS) provides emergency tones and voice messages through
100V loudspeakers to aid in the evacuation of occupants from buildings during emergency situations.
2. Installation
WARNING: Installation should be performed by competent persons in accordance with the
relevant standards as required for the installation. Honeywell Ltd accepts absolutely no liability
for the suitability, placement or settings of the speakers within an installation.
1. Remove power from the panel.
2. Fit the supplied standoffs to the CHS style mounting plate.
3. Mount the DA-60 as shown in Figure 1 and use the supplied screws to fasten it to the CHS mounting plate.
4. Connect the 20 way ribbon cable from the DA controller & pre-amp to the DA-60 using the 20 way header
as per Figure 1.
Figure 1 - DA-60 on CHS-3L connected to DA Controller & Preamp
5. Wire in the 24V battery backed power supply to the 0V and 24V terminals on the DA-60; see Figure 2.
6. Complete the pre power up checks as described in the DA manual prior to applying power to the DA-60.
7. Refer to the DA manual for information on programming and connection of ancillaries.
NOTE: Do not remove the red jumper fitted to the ribbon cable header on the left hand
side of the DA-60 unless networking with another DA module. Refer to manual for
detailed connection and programming information of networked systems.
9 ColumbiaWay
Baulkham Hills, NSW 2153
PH 02-9894-1444 • FAX [phone]
www.notifier.com.au
Notifier 60W Digital Amplifier (DA-60)
Product Installation Document
DOC
-
03
-
007
ECN09
-
053
16
/
0
7
/200
9
Rev:
1.0
0

ECN09
-
053
2
Figure 2 - DA-60 Connection Diagram
3. Components
The DA-60 kit (ASY-02-003) is supplied with the components outlined in Table 1.
Part No. Description Qty
PCA-01-009 DA-60 BOWS – 60W Digital Amplifier with built-in tones and voice messages 1
GEN-01-001 4-40 x 5/16” SEMS Philips head screw 2
GEN-01-002 4-40 UNC Spacers, 19mm height 2
- 47K, 1 Watt resistor fitted to the speaker output 1
- RIB-20-0340 - 340mm, 20 way ribbon cable for network connection 1
DOC-01-004 Notifier DA Series BOWS – Installation and Programming Manual 1
Table 1: Components
4. Supplemental Documentation
For information on... Refer to... Part No.
DA Series Amplifiers Notifier DA Series BOWS – Installation and Programming Manual DOC-01-004
Table 2: Supplemental Documentation