Honeywell SILENT KNIGHT 5860 Technical manual

2 Clintonville Road, Northford, CT 06472-1610 USA
03-484-7161 • FAX [phone] • www.silentknight.com
5860 Remote Annunciator
Product Installation Document
PN 151042:D 07/01/2017 ECN 16-0218
5860 Remote Fire Annunciator
The 5860, an optional 4x20 remote annunciator, is
shown in Figure 1, it can be surface or flush-
mounted.
Figure 1: Model 5860 Remote Annunciator
Compatibility
The 5860 is compatible with Honeywell’s Silent
Knight FACP's.
Note: For more information, see the FACP Installation manual.
Specifications
Figure 2: Annunciator Dimensions
Mounting
The annunciator can be flush or surface mounted.
Surface Mounting
The Model 5860TG (gray) and 5860TR (red) trim ring
kits are available for use when surface mounting.
Figure 3: Surface Mounting
Parameter Value
Operating Voltage: 24 VDC
Current Standby: 25 mA
Alarm: 50 mA
Operating
Temperature: 0° to 49° C (32° to 120° F)

Silent Knight®, JumpStart®, and Honeywell®are registered trademarks of Honeywell International, Inc.
2 5860 Installation Document — P/N 151042:D 07/01/2017
Flush Mounting
Follow these steps to flush mount the 5860:
Figure 4: Flush Mounting
Wiring Connections
Wire the 5860 to the FACP as Shown in Figure 5.
Figure 5: SBUS Connections
Installing the 5860
5860 installation involves the following steps:
1. Ensure power is turned off at the panel.
2. Mount the 5860 in the desired location.
3. Connect the 5860 to the panel (see Figure 5).
4. Use the DIP switches on the back of the 5860 to
assign an ID number. (see FACP manual).
5. The new 5860 module must be added to the
system through programming. JumpStart®will
add the module automatically. Refer to the FACP
manual for more information.
Mounting Holes
supervised
power limited