Horizon Fitness MINIPAK User manual

MiniPak
USER GUIDE

MiniPak sealable protective bag
Cellphone charging tips
Accessories included in this box:
SYSTEM OVERVIEW
The MiniPak micro-fuel cell power supply is a
universal handheld charger and power extender
compatible with devices requiring DC 4.2V-5V and
about 300MA power input. The system includes
several adaptor tips for charging different
cellphones, GPS, digital cameras, etc., and can
power numerous 5V DC devices.
Please read the following information carefully to
avoid potential damage to the device.
Flashing red = Start up/Shut down
Flashing blue = Ready
Continuous blue light = Working
LED status indicator light:
1
cartridge bay
LED status indicator
USB port
fuel cell air vent
purge outlet

MiniPak handheld fuel cell power supply
SPECIFICATIONS
2
3.8-5
13 214 11.5 6.9 2.7
7
7.4
5
3.2 oz /
C
Hydrogen purity 99.99%
Hydrogen capacity

- Fuel cartridge contents are flammable.
- Avoid contact with contents.
- Do not expose to temperature above 50 °C or open flames.
- Keep away from children.
- Follow usage instructions.
- Do not tamper, disassemble or puncture the MiniPak or HYDROSTIK.
- Keep MiniPak and HYDROSTIK away from fire, open flame, or heat source.
- The MiniPak shall be used in a well-ventilated area.
- Wait for LED indicator to flash blue before connecting external devices.
- Do not connect while red light is flashing.
- Remove HYDROSTIK immediately after use.
- Do not keep used or empty HYDROSTIK connected to MiniPak.
- Carefully store the MiniPak in the protective bag after use, store Hydrostik separately.
SAFETY & MAINTENANCE: Read carefully before proceeding
3

ACTIVATING THE MINIPAK
4
Insert HYDROSTIK into the cartridge bay and turn clockwise until connection is tight.
Once connected the LED status indicator light should start flashing red.
Wait for LED to flash blue.

USING THE MINIPAK TO CHARGE OR POWER YOUR DEVICES
A. HYDROSTIK should be connected and a blue light should be flashing.
(Do not connect if red light is still flashing)
B. Connect your device to MiniPak with a USB cable.
C. Place your MiniPak in an upright position.
D. After use, remove HYDROSTIK from MiniPak. The indicator light will turn off in one minute.
5

- To avoid permanent damage to your MiniPak, please make sure the HYDROSTIK is removed from the
MiniPak system immediately after use. Failing to do so may permanently damage your MiniPak.
- Air vents located on either side of the MiniPak need easy access to ambient air.
- Do not cover MiniPak with anything when it is in use.
- Fuel cells combine hydrogen and oxygen to generate water, heat and electricity. It is normal to see condensed
water droplets.
REFILLING EMPTY HYDROSTKS
A. HYDROFILL (sold separately) can be used to refill your HYDROSTIK. Check with your vendor for availability.
B. Contact your vendor for local refilling solutions nearby.
6
NOTES:
STORING YOUR MINIPAK AFTER USE
A. Make sure to store MiniPak in the protective bag provided and seal it tight for storage after use.
B. Keep HYDROSTIK stored separately.

TROUBLESHOOTING
• INDICATOR LIGHT CONTINUES TO FLASH RED, DOES NOT FLASH BLUE
Solution 1: Check whether MiniPak is placed upright and whether both sides of MiniPak has sufficient access
to air.
Solution 2: Check whether purge outlet is covered.
Solution 3: Remove HYDROSTIK from MiniPak, wait for red light to come off, and insert HYDROSTIK again.
If it does not work, the HYDROSTIK might be empty, replace it with a full one.
• INDICATOR LIGHT DOES NOT TURN ON AFTER HYDROSTIK IS CONNECTED
Solution 1: Make sure HYDROSTIK is connected tightly to the MiniPak.
Solution 2: Use a full HYDROSTIK.
Solution 3: You may have left HYDROSTIK connected to the MiniPak without using the system for long time,
which might have damaged the fuel cell.
•WATER DROPLETS START TO FORM UNDER THE MINIPAK
Solution: Position the MiniPak upright during operation so both its air vents can access ambient air.
• MY DEVICE DOES NOT CHARGE WHILE THE BLUE INDICATOR LIGHT IS ON
Solution 1: Check all the connections to make sure MiniPak is operating appropriately.
Solution 2: Some devices, like iPhone 4 or iPad, sometimes may show “Charging is not supported with this
accessory”, however, as long as the blue light is ON, MiniPak is still charging but at a slower speed.
Solution 3: Please also try disconnect and reconnect your device with MiniPak, the error message may go
away after that and your device will be charged at normal speed.
• THE MINIPAK SURFACE IS WARM
Solution: The fuel cell will heat up during operation, this is normal. 7
FCHP-02_MiniPak_UM_V2.5_EN