Hoshizaki HLF 10 User manual

Water ltration
For Ice Machines
Water ltration
For Ice Machines
Filter Head incl. valve
½” bspm inlet, ball valve
¾” bspm outlet
Cartridge Selection
HLFC 100 Standard
Suits small ice machine
applications
HLFC 200 High Capacity
Suits medium/high
volume applications
Hoshizaki Water Filter System
Improves ice and beverage quality, optimises equipment performance and service life
Sediment and chlorine reduction improves water & ice quality to enhance beverage•
appearance and taste.
Reduces hardness scale to protect and extend equipment life.•
Sanitary quick change design – easy to use and hygienic to change out lter cartridges.•
Range of sizes and capacities to suit applications.•
Manufactured in USA. International independent performance certication.•
Water related issues are the most common cause of ice machine problems. Hoshizaki provide a quick change
water lter system to enhance ice quality and extend the performance and life of ice machines. The lter
system features a quick change sanitary design which enables easy installation and use, and also protects
against water contamination by eliminating handling of the lter media. The lter system is available in two
convenient sizes to suit a range of applications and can utilize a range of cartridges. The system comprises of (i)
Mounting Bracket, (ii) Filter head c/w all valve and threaded in/out ttings and (iii) Filter cartridge.
Please contact your Hoshizaki office for further information.
Specications
Description
Filter systems complete
Filter system – standard capacity 320mm ctg
includes bracket, filter head and cartridge
Filter system – high capacity 450mm ctg
includes bracket, filter head and cartridge
Replacement lter cartridges
Filter cartridge – standard capacity 320mm
- Sediment, chlorine, scale
Filter cartridge – high capacity 450mm
- Sediment, chlorine, scale
Parts
Filter head 1/2”bspm inlet 3/4”outlet
Mounting bracket
BallValve 3/8m x 3/8f
Mounting bracket
– plastic
Standard
HLFC 100
High Capacity
HLFC 200
Model
HLF 10
HLF 20
HLFC 100
HLFC 200
QCELH Contact Hoshizaki
BKTMF Contact Hoshizaki
FPV3838 Contact Hoshizaki
Operating Conditions
Connections In/Out: inlet 1/2”bspm, outlet 3/4”bspm
Water Pressure range: 100 kPa – 900 kPa
Temperature range: 2⁰C - 40⁰C
Flow rate: < 8 lpm
Notes
Filter cartridge life: Dependent on water quality. 6 months recommended use period, 12 months maximum.
Protect filter system from freezing or direct sunlight.
Fit pressure limiting valve if water pressure is >900 kPa
Not for use in water that is microbiologically unsafe or of unknown quality without adequate disinfection
QCELH BKTMF
Dimensions
HLF10 system – 390mm h x 100mm w
HLF20 system – 520mm h x 100mm w
HLFC100 cartridge – 320mm h x 100mm w
HLFC200 cartridge – 450mm h x 100mm w
Suits Ice Machine models
IM30 – IM100, KM30 – KM125, DCM series
IM130 – IM240, KM515 – KM1300
QCELH

Food Service > Water Filtration
BROCOF 0809
Installation
Please read instructions carefully prior to installation
1The lter system is installed between the water supply point and the ice
machine. The lter should be mounted on a rm vertical surface close to
the ice machine and for easy access.
2A plastic ball valve is supplied to be installed on the inlet of the lter
head so the water supply can be isolated for lter cartridge changeout. If
water pressure is above 900 kPa a 600 kPa pressure limiting valve should be
installed between the isolating valve and the lter system.
3Suitable food grade hose or pipework should be used to connect the lter
sytem. The lter system has a ½”bspm threaded inlet which is connected to
the inlet of the plastic ball valve. The plastic ball valve outlet is connected
to the inlet of the lter head. A ¾”bspm threaded outlet is supplied which
allows connection to hoses used.
4The mounting bracket is connected to the lter head with the 4 screws
provided. The mounting bracket and head should be installed in a suitable
location – ensure 100mm is allowed below bottom of the installed lter
cartridge to provide room for cartridge change out
5The lter cartridge is installed into the lter head by aligning the guide
arrows, pushing the cartridge upwards into the head, quarter turn right to
lock in the cartridge.
6First Flush – A rst ush is recommended to clear air from the new
system. Turn the inlet water supply valve on slowly whilst holding the
outlet hose into the bucket or drain. Air will be ushed through the lter in
a few litres. Once the water clears the inlet valve can be turned o and the
lter outlet hose can be connected to the inlet of the ice machine. The inlet
water supply can be slowly turned on. Check for and x any leaks.
The lter cartridge should be changed when any of the following occurs –
1The ltered water ow reduces substantially
2Taste/Odour occurs in the ltered water
3The maximum service period expires
Filter changeout instructions
1Turn o water supply at the ball valve prior to the lter system. Hold and
turn the lter cartridge a quarter turn to the left, pull down and remove the
cartridge. Be careful as residual water pressure may be present.
2Take the new replacement cartridge. Line up the guide arrows on the
cartridge and head and push the cartridge into the lter head and then do
a quarter turn to the right which locks in the lter cartridge.
3First Flush – A rst ush is recommended to clear air from the new
cartridge. Turn the inlet water supply ball valve on slowly whilst holding the
outlet hose into the bucket or drain. Air will be ushed through the lter in
a few litres. Once the water clears the inlet ball valve can be turned o and
the lter outlet hose can be connected to the inlet of the ice machine. The
inlet water supply can be slowly turned on. Check for and x any leaks.
Installation and lter change instructions
Recommended Installation
Pressure
Limiting
Valve - optional,
if pressure
is > 900 kPa
Water Flow
Ball Valve
supplied
Stop Cock
Mounting bracket
To remove cartridge
turn in this direction
Filter System HLF 10 Filter System HLF 20
Water Flow
Filter System HLF 20
Filter Housing Head
To install cartridge
turn in this direction
Ice Machine
To Install
To remove cartridge
turn in this direction
Cartridge pushes into
head to install
Cartridge pulls out
of head to remove
To install cartridge
turn in this direction
Filter Life Indicator
3
6
1
Each Hoshizaki lter cartridge comes with a
lter life indicator label for recommended
ecient and hygienic use of the lter.
Simply adhere the label to the lter or in a
convenient location, press the START button
when the lter cartridge is installed and the
label will measure elapsed time till the
6 months recommended use period is
reached.
S
E
R
V
I
C
E
F
I
L
T
E
R
6
M
O
N
T
H
S
SOUTH AUSTRALIA
ADELAIDE (HEAD OFFICE)
PO Box 331
Welland SA 5007
5Toogood Avenue
Beverley SA 5009
Tel: [phone]
Fax: [phone]
Sales - [email protected]
VICTORIA - MELBOURNE
and TASMANIA
30Vernon Avenue
Heidelberg Heights
VIC 3081
Australia
Tel: [phone]
Fax: [phone]
Sales - [email protected]
NEW SOUTH WALES -SYDNEY
Unit 8, 2 Holker Street
Newington NSW 2127
Australia
Tel: [phone]
Fax: [phone]
Sales - [email protected]
QUEENSLAND - BRISBANE
Unit 27, 256-258 Musgrave
Road
Coopers Plains QLD 4108
Australia
Tel: [phone]
Fax: [phone]
Sales - [email protected]
WESTERN AUSTRALIA - PERTH
24 Ernest Clark Road
CanningValeWA 6155
Australia
Tel: [phone]
Fax: [phone]
Sales - [email protected]
System supplied by Hoshizaki and Water Filter Services Pty Ltd.