Parts Assembly con’t
2
Assembly
1
NOTE: Finger tighten screws until fully assembled.
1. Align front panel (A), groove side down, to side panel (D). Turn cam locks to secure.
Insert pivot hinge (N) into right side panel (D). See diagram 5.
2. Align top back panels (E & F) to side panel (D) with cam nuts to the back.
Turn cam locks to secure. See diagram 6.
3. Slide middle back panel (H) into groves in back panels (E and F).
Slide floor panel (G) into grooves on front panel (A) and lower cross brace (F). See diagram 7.
6. Insert dowels (O). See diagram 8.
7. Place left side panel (C) onto assembly. Make sure panel aligns with cam bolts, hinges,
and back and floor panels. Turn cam locks to secure. See in diagram 9.
8. Insert hanging bars (I) through top of bag (K). Lay into notches inside hamper bench.
See diagram 10.
9. Place cushion (J) on top of lid. See in diagram 11.
Diagram 5 Diagram 6 Diagram 7
Diagram 8
Diagram 10
Diagram 11
Diagram 9
1. Screw cam bolts (L) into left and right side panels (C & D).
Insert wood dowels (O) into right side panel (D). See diagram 1.
2. Attach seat support (S) into left and right side panels (C & D) using screws (T).
2. Lay front panel and back panels (A & E) face down and attach notched bag supports (Q)
to panels with screws (P). Insert cam locks (M) into front panel (A). See diagram 2.
3. Insert cam locks (M) into top back panel (E) and lower cross brace (F). See diagram 3.
4. Insert short side of pivot hinge (N) into groove on lid (B). Secure with 2 self tapping screws (R). See diagram 4.
Diagram 1 Diagram 2
Diagram 3 Diagram 4
CD
RR R R
B
Q
A
E
Q
Ax1
Front Panel
Lx10
Cam Bolt
Hardware
Bag Mx10
Cam Lock
Nx2
Pivot
Hinge
Ox8
Wood
Dowels
Px4
Self Tap
Screws
Rx4
Self Tap
Screws
Tx6
Self Tap
Screws
Qx2
Notched Bag
Support
Sx2
Seat Support
Ex1
Top Back Panel
Fx1
Lower
Cross Brace
Gx1
Bottom Panel
Hx1
Middle
Back Panel
Jx1
Cushion
Ix2
Hanging
Bars
Kx1
Bag
Bx1
Lid
Cx1
Left Side Panel
Dx1
Right Side Panel
S
T
T
T
T
T
T
S
Location for Pivot
Hinge (N)
