Howdens HYH1323 User manual

Important Notes:
Do not use a power driver for this product installation
Ensure packaging is disposed of in a safe environmentally friendly way
Installation into a 600mm cabinet required which has been secured to the wall
Cabinet door(s) must be able to open fully for the pull down mechanism to operate
This mechanism has moving parts and care must be taken when operating.
Only use the handle to pull down.
Care must be taken when pulling the shelving up and down. Hold the handle until fully extended or retracted.
600mm Pull Down Shelving
HD417081 HYH1323
Installation Overview
HYH1323
Fit the shelf racks to the LH side panel aligning the rack
with the holes. Secure in 4 positions with screws.
*Lever adjustment required dependent upon weight. Set to heavy for installation (see operation information)
1Fit the handle bar slotting it into position.
2
Storage load: Up to 9kgs*
Assembly
600mm
564mm
409mm
18mm
442mm
19mm
270mm
290mm
412mm
614.5mm 684mm 720mm
18mm
Handle
Bar x1
LH Side Panel x1
Screw x4
(4x16mm)
Washer x4
Note: Make sure the
slot is located
270mm
Shelf Racks x2

RH Side
Panel x1
Screw x4
(4x16mm)
HYH1323
Fit the RH side panel to the shelf racks aligning the
holes in the side with the rack and handle bar.
Secure rack in 4 positions with screws.
3
7Fit the pull down shelving assembly into the cabinet,
locating the tops of the mechanism into the plate
holding slots on the sides.
Adjust the weight lever on the side of the basket depending on the load (see below).
Note: Weight selector lever should be set to maximum for installation. Only adjust when shelving is stored away.
8
Unit Operation and Adjustment
Fit the connection bar to the mechanisms.
Note: Fully tighten once basket has
been fitted in the next stage.
LH Side
Assembly
Right Side
Fixing Plate x1
Connection
Bar x1 Bolt x4
(M5x10mm)
Set to light Set to heavy
Note: Make sure the plate is located
into the slot. Push together to ensure
the bolt locates into the holes.
Slots
Bolt x4
(M4x8mm)
Screw x4
(4x16mm)
Screw x4
(M5x8mm)
HEAVY
LIGHT
LIGHT - 0-5kgs HEAVY - 4-9kgs
344mm
128mm
55mm
130mm
205mm
230mm
120mm
Screw x6
(4x14mm)
431mm
128mm
55mm
140mm
225mm
248mm
160mm
RH Side
RH Side
5Fit the fixing plates to each side of the cabinet
aligning the brackets with the spiked hole
positions.
CAUTION: Care must be taken when
handling the brackets. Moving parts
can lead to finger entrapment if
care is not taken
LH Side
Left Side
Fixing Plate x1
RH Side
6Fit the LH & RH brackets to the fixing plates, slotting them into position.
Secure the brackets to the cabinet and fixing plates using the screws and bolts
as show.
LH Side
Washer x4
Spring Washer x4
4Mark and spike the cabinet side
panels for the fixing plates.
Washer x4